BURNER CONTROL KIT GeniSys™

GeniSys™

ADVANCED BURNER CONTROL

The Beckett GeniSys™ oil burner primary controls are an advanced design available with programmable valve on delay and motor off delay.

Three indicator lights monitor system and cad cell, as well as offer service diagnostics. Two communication ports for adding an alarm module, programming display, or future wireless communications. Relays incorporate Technician pump prime mode (valve on delay and motor off delay can be programmed with the use of program- ming display module, which will be available in the near future).

CAT. NO. MFG. NO. LOCKOUT VALVE ON MOTOR OFF EACH 4H468

7505A 0000 15 seconds None None 4H468A 4505B 1500 15 seconds 15 sec. delay None

Beckett has combined all of the accessories for the GeniSys™ control into one kit. This is a convenient and durable tool box to be carried as a service kit. The kit components can be replaced indi- vidually as used. Kit contains: (1) GeniSys™ 705A000U, (1) Geni- Sys™ 7505B1500U, (1) GeniSys™ Contractor Tool 52082U, (1) GeniSys™ Lockout Alarm 52040U and (1) AC Ready Kit 51950.

CAT. NO. MFG. NO. DESCRIPTION EACH 4H468G 52097U GeniSys™ Burner Control Kit $430.57

$120.45 $120.45

4H468B 7505P 152M 15 seconds 15 sec. delay 2 min. delay $120.45

PROGRAMMING MODULE & ALARM MODULE For Genisys Burner Controls

The Beckett “Programming Display Module” can be used to read previous fault codes, and to program the Geni-

GeniSys™ CONTRACTOR PROGRAMMING TOOL

The Beckett Contractor Pro- gramming Tool is a rugged instrument which is built to withstand the rigors of a ser-

vice tool. Although it performs the same functions as the Display/ Programming Module, the contractor Programming Tool is built for re-use time and time again. The Display/Programming Module is not made for continuous duty. This tool allows contractor pro- gramming of the GeniSys™ controls to meet job site requirements. It also allows the service person to review previous fault codes to aid in analyzing problems. Lockout safety timing, pre-purge and post purge function settings can be programmed at the site thru connection with an easy plug in harness. Use of this tool allows one GeniSys™ relay to replace most burner cad cell safety relays in use today.

CAT. NO. MFG. NO. DESCRIPTION EACH 4H468F 52082U GeniSys™ Contractor Programmign Tool $133.83 CAT. NO. MFG. NO. DESCRIPTION EACH 4H468D 52049U Genisys docking module $342.43

sys series burner relays. Easy snap on mounting allows read out of previous faults, and allows programming of the relay to meet the requirements of the installation. Lockout safety timing, prepurge and post purge function settings can be programmed at the site. The module can remain attached to the control for tracking pur- poses, or be removed and used to program additional controls. Use of this module allows one Genisys relay to replace most burner cad cell safety relays in use today.

CAT. NO. MFG. NO. DESCRIPTION EACH 4H468C 52067U Genisys programming module $77.15

The Beckett “Alarm module” can be added to the Genisys series burner relays, provid- ing a set of dry contacts for connection to an alarm. Easy snap on mounting.

CAT. NO. MFG. NO. DESCRIPTION EACH 4H468E 52040U Genisys alarm module $36.95

The Beckett “Docking module” is used to test and program controls when not con- nected to the burner.

762

CONTROLS