RESEARCH REVIEW
Debut for double-quantum-well tunnel FET Novel tunnel FET targets low power and radio frequency applications
ENGINEERS FROM MIT are claiming to have fabricated the first tunnel FET with a double quantum well InGaAs/GaAsSb structure.
Additional accomplishments for this team, which work at the Microsystems Technology Laboratory, are a first demonstration of area-dependent drive current for this class of device and the realisation of backward-diode operation characteristics (backward diodes deliver their highest current when reverse biased, due to tunnelling of carriers).
This team’s novel FET is a promising device for two types of application: It has the potential to deliver a very low sub-threshold swing – a measure of the change in voltage needed to increase the drive current by an order of magnitude – making it attractive for low power applications; and as a backward diode, it could find deployment in radio frequency applications for mixing and detection.
One of the team’s motivations for developing its double quantum well TFET has been to expand the drive current range capable of delivering a low sub- threshold swing. Previous forms of TFET have demonstrated a sub-60 mV/decade sub-threshold swing, but only at low drive currents.
In 2011, Sapan Agarwal and Eli Yablonovitch from the University of California, Berkley, unveiled the results of theoretical investigations, which suggested that density-of-state switching is capable of realising a steep sub- threshold swing over a wide range of drive currents. In order to produce this form of switching, the TFET must feature two quantum wells overlapping in the confinement direction.
The MIT device exhibits this trait, with wells formed by an 18-nm thick p-type GaAs0.5
Sb0.5
a concentration of 1019 15 nm-thick n-type In0.53
cm-3 , and a Ga0.47 As layer
doped with silicon to a concentration of 1017
. These epilayers were
deposited onto a semi-insulating InP substrate by MBE (see Figure).
Device fabrication involved: patterning with e-beam lithography; the addition of a HfO2
gate dielectric, which is
5.3 nm-thick, by atomic layer deposition; and removal of GaAsSb to suspend an InGaAs air bridge via a highly selective wet etch. Depositing a layer of Al2
O3 passivated the device.
Measurements by the team show that the current delivered by their TFET is proportional to its gate area. Four devices were used to determine this, with
gate areas ranging from just above 10 μm2
to almost 90 μm2 .
A weakness of the device is its high sub-threshold swing: its minimum value is 140 mV/decade, and it has an effective value of 220 mV/decade over 20 nA to 2 µA.
layer doped with beryllium to cm-3
The engineers from MIT believe that one of the causes of the high sub-threshold swing is the high off-current. This may originate from leakage through the 30 nm-thick InP buffer layer, and could be addressed by undercutting the InP layer under the drain current.
Another reason for the high sub- threshold swing is the high density of interface traps, which are located in the InGaAs conduction band at the HfO2
/InGaAs interface.
According to capaitance-volatge measurements, the minimum value for the denisty of interface traps is 2 x 1012
cm-2 eV-1 .
“The density of interface traps is mainly due to the dangling bonds on the InGaAs surface, prior to dielectric deposition,” explains Tao Yu from MIT, who believes that these traps might be minimised with a passivation step involving chemical methods or plasma treatment.
Measurements of the gated-diode nature of the TFET reveal that it exhibits tuneable backward diode behaviour. The gate bias can be adjusted to optimise minimum noise or high sensitivity.
“We have not yet done a deeper study on the actual RF performance of the device, but according to previous studies on backward diodes, the RF application of the device should be promising after calibration and optimisation,” says Yu.
Other plans for the team are to suppress the interface trap density, cut leakage and improve sub-threshold swing through optimisation of the gate dielectric and device architecture.
Engineers from MIT have fabricated a double quantum well FET (a). Cross-sectional tunnelling electron microscopy provides images of the tunnelling junction and gate stack in the gated region (b), and the edge of the InGaAs air bridge (c). A top view of the air-bridge, after suspension, is provided by a scanning tunnelling microscope (d).
60
www.compoundsemiconductor.net January / February 2014 T. Yu et. al. IEEE Electron Dev. Lett. 34 1503 (2013)
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56 |
Page 57 |
Page 58 |
Page 59 |
Page 60 |
Page 61 |
Page 62 |
Page 63 |
Page 64 |
Page 65 |
Page 66 |
Page 67 |
Page 68 |
Page 69 |
Page 70 |
Page 71 |
Page 72 |
Page 73 |
Page 74 |
Page 75 |
Page 76 |
Page 77 |
Page 78 |
Page 79 |
Page 80 |
Page 81 |
Page 82 |
Page 83 |
Page 84 |
Page 85 |
Page 86 |
Page 87 |
Page 88 |
Page 89 |
Page 90 |
Page 91 |
Page 92 |
Page 93 |
Page 94 |
Page 95 |
Page 96 |
Page 97 |
Page 98 |
Page 99 |
Page 100 |
Page 101 |
Page 102 |
Page 103 |
Page 104 |
Page 105 |
Page 106 |
Page 107 |
Page 108 |
Page 109 |
Page 110 |
Page 111 |
Page 112 |
Page 113 |
Page 114 |
Page 115 |
Page 116 |
Page 117 |
Page 118 |
Page 119 |
Page 120 |
Page 121 |
Page 122 |
Page 123 |
Page 124 |
Page 125 |
Page 126 |
Page 127 |
Page 128 |
Page 129 |
Page 130 |
Page 131 |
Page 132 |
Page 133 |
Page 134 |
Page 135 |
Page 136 |
Page 137 |
Page 138 |
Page 139 |
Page 140 |
Page 141 |
Page 142 |
Page 143 |
Page 144 |
Page 145 |
Page 146 |
Page 147 |
Page 148 |
Page 149 |
Page 150 |
Page 151 |
Page 152 |
Page 153 |
Page 154 |
Page 155 |
Page 156 |
Page 157 |
Page 158 |
Page 159 |
Page 160 |
Page 161 |
Page 162 |
Page 163 |
Page 164 |
Page 165 |
Page 166 |
Page 167 |
Page 168 |
Page 169