108 FORMULATIONS
Vegetable Glycerin Glycerin Geogard Ultra
Gluconolactone, Sodium Benzoate, Calcium Gluconate
PenCare™ DP 1015 Starch Hyroxypropyltrimonium Chloride Montanov L Cetiol C5
Saboderm TCC Caprylic/Capric Triglyceride Amigum
Sclerotium gum Water soluble actives Sodium Hydroxide, Sodium Hydroxide
20% solution to pH 5.0-5.2
Procedure
Heat the water of phase A to 70 - 75°C and dissolve the Geogard Ultra preservative. Mix the PenCare™ DP 1015 with the glycerin and add to phase A. Stir until homogeneous. Heat phase B to 70 - 75°C and add to phase A with stirring. Homogenise briefly until the emulsion is formed. Sprinkle in the Amigum and start paddle stirring. Stir until cool, adding any sensitive actives below 40°C. Homogenise again briefly. Adjust the pH as shown.
INNOVACOS Active Hair Oil
PHASE INGREDIENTS/INCI NAME A Coco-Caprylate
Propylheptyl Caprylate Coco-Caprylate/Caprate Caprilyc/Capric Trygliceride
(and) Polyhydroxystearic Acid (and) Octyldodecanol - innollient™ LO Raphanus Sativus (Radish) Seed Extract (and)
Octyldodecyl Oleate (and) Octyldodecanol (and) Magnolia Officinalis Bark Extract (and) Rosmarinus Officinalis (Rosemary) Leaf Extract - ActivoilTM Kerox-ProTM Tocopheryl Acetate Parfum
Procedure Blend all the ingredients in the given order; Stir until clear.
Properties Viscosity: After 24h Brk, RVDV-I Prime, Sp 01, 50 rpm ~ 20 cps Suppliers 1 Emollient 2 Active Ingredient
3 Antioxidant
JEEN INTERNATIONAL OptiDermTM
Remedy Lotion
PHASE INGREDIENTS A Wate1
Jeecide®
PEN-NAT1 Jeesperse® Optiderm™1
INCI NAME Deionized Water Pentylene Glycol DL-PanthenoL1 B Jeechem®
Squalane Natural1 Avocado Oil1
Shea Butter1 Argan2
September 2018
(and) Dehydroxanthan Gum (and) Cetearyl Glucoside (and) Triticum Vulgare (wheat) Germ Oil (and) Hydroxypropyl Bispalmitamide Mea Panthenol Squalane
Persea Gratissima (avocado) Oil
Sweet Almond Prunus Amygdalus Dulcis Oil NF1
(sweet Almond) Oil
Shea (butyrospermum Parkii) Butter Argania Spinosa Kernel Oil
2.2500 2.0000
4 Parfum
3.00 1.20
0.50
C14-22 Alcohols, C12-20 Alkyl Glucoside 3.00 Coco-Caprylate
5.00
12.00 0.80 q.s. q.s.
Jeechem®
CTG1 Olive Oil (Pure)1
C Aerosil 200 LEMON OIL2
Sandalwood Oil2 JEECIDE® AA PLUS1
Procedure
PHASE A In main beaker, add Phase A ingredients mixing with propeller mixer and heat up to 30-35C. Transfer Phase A to homomixer maintaining the temperature 30-35C for 5-10 min. PHASE B In side beaker add Phase B ingredients mixing with propeller mixer and heat up to 30-35C. Slowly add Phase B to Phase A. Continue mixing Phase AB for 10-15 minutes with homo- mixing. Switch to side sweep mixing. PHASE C Add Phase C ingredients one at the time to Phase AB at 25-30C and mix until homogeneous. Adjust Ph. Properties
pH: 5.00 - 6.00 Viscosity: RV SP-TC@ 5rpm 1min.@25C 17500 - 222500 Suppliers 1 JEEN 2 BotanicalsPlus
Octyldodecyl Oleate (and) Octyldodecyl Stearoyl Stearate
FD 22-04-01A % W/W 30.00 27.25 23.00 12.00 2.00
5.00
NATURA-TEC Tattoo Yor Lips PHASE INGREDIENTS
Caprylic/capric Triglyceride Olea Europaea (olive) Fruit Oil Silica
Citrus Medica Limonum (lemon) Peel Oil
Santalum Spicata Wood Oil
Benzyl Alcohol, Pentylene Glycol, Benzoic Acid, Sorbic Acid
6.2500 3.1000 0.1000 0.4200
0.5200 1.0000
INCI NAME
A Deionized Water Aqua (Water) Rice Starch1
Glycerin B Abysoft1
0.50 a.n.
Red 7 Ca. Lk2 Synthetic Iron
Oxide Red2 Titanium Dioxide3
C Geogard ECT Oryza Sativa (Rice) Starch
Satiaxane UCX 911 Xanthan Gum Glycerin – Organic1
Crambe Abyssinica Seed Oil Phytosterol Esters
Suncroma FD&C CI 15850 CI 1975 CI77891
Benzyl Alcohol (and) Salicylic Acid (and) Glycerin (and) Sorbic Acid
Sodium Hydroxide Sodium Hydroxide (25% sol)
1803A-TYL % W/W
Up to 100 10.00 0.30 3.00
10.00 3.00 2.00
0.50 0.50
q.s.
J38-107 % W/W 68.610 5.000
Cetearyl Alcohol (and) Glyceryl Stearate 3.5000
Procedure At room temperature, mix the phase A and the phase B separately. Heat phase A and B above 60°C. At temperature, add B to A whilst stirring. Homogenize using Ultra Turrax (3 min at 15000 rpm). Allow to cool down whilst stirring moderately.
Add phase C below 40°C whilst stirring moderately for few minutes. Adjust pH if necessary.
Properties
Appearance: Light and aqueous texture with a velvety finish. Apply with a pencil.
pH = 7 - Viscosity (20°C): 145 802 mPa.s (LV4;2 rpm) Suppliers 1 Natura-Tec
2 Sun Chemical 3 ACEF 4 Lonza
0.2500 2.0000
2.0000 3.0000
RITA CORPORATION Natural Shampoo with Pearl PHASE INGREDIENTS A1 D.I. Water A Esaflor EC41
B Ritafactant 138AN1 Eucarol Age/EC1
INCI NAME Aqua
Guar Hydroxypropyltrimonium Chloride Decyl Glucoside, Sodium Lauroyl Lactylate
Disodium Coco-glucoside Citrate
REF: 146-168E % W/W 51.45 0.70
35.00 10.00 PERSONAL CARE EUROPE
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56 |
Page 57 |
Page 58 |
Page 59 |
Page 60 |
Page 61 |
Page 62 |
Page 63 |
Page 64 |
Page 65 |
Page 66 |
Page 67 |
Page 68 |
Page 69 |
Page 70 |
Page 71 |
Page 72 |
Page 73 |
Page 74 |
Page 75 |
Page 76 |
Page 77 |
Page 78 |
Page 79 |
Page 80 |
Page 81 |
Page 82 |
Page 83 |
Page 84 |
Page 85 |
Page 86 |
Page 87 |
Page 88 |
Page 89 |
Page 90 |
Page 91 |
Page 92 |
Page 93 |
Page 94 |
Page 95 |
Page 96 |
Page 97 |
Page 98 |
Page 99 |
Page 100 |
Page 101 |
Page 102 |
Page 103 |
Page 104 |
Page 105 |
Page 106 |
Page 107 |
Page 108 |
Page 109 |
Page 110 |
Page 111 |
Page 112