90 FORMULATIONS
Covarine Red WN 3798
Iron (III) Oxide (and) Aqua (and) Glycerin (and) Xanthan Gum (and) sodium Citrate 1
0.02
Procedure: Heat water up to 40°C. Pre-disperse xanthan gum in glycerin and add to the water. Heat phase A and B at 70°C. At temperature add phase B into A whilst stirring. Homogenize using Ultra Turax (2min at 10000 rpm). Allow to cool down whilst stirring moderately. Add sensitive phase C below 40 ° C. Properties: Appearance : Bright and light coloured fluid emulsion. pH= 5.6 Viscosity (20°C): 8 000 mPa.s (LV3; 5 rpm)
Suppliers: 1. Sensient
E Sodium Benzoate and Potassium Sorbate Hydrachrysum™ Aqua/Water Sepifine™ BB
Parfum/Fragrance
1.00 1.00 5.00 1.00 0.05
SEDERMA
BLEMISH JELLY ERASER WITH MEL[O]STEM™ MBAL SE0236C AND BB-BIONT™ MBAL PHASE INGREDIENTS/ INCI NAME
A Water Deionised (Aqua) Potassium Sorbate
Red clay ER (Illite (and) Kaolin)
B Water Deionised (Aqua) Lactic Acid
C Glycerin
Pentylene Glycol Propanediol
Kelcogel® CG-HA (Gellan Gum) Xanthan Gum FNCS-PC (Xanthan Gum)
D Syncrowax™ ERLC (C18-36 Acid Glycol Ester) SP Cithrol™ GMS SE 40 MBAL (Glyceryl Stearate SE) Syncrowax™ HRC (Tribehenin)
E Crodarom® Nordic Cotton (Water (and) Glycerin (and) Eriopho- F BB-Biont™ MBAL
rum Spissum Flower/Stem Extract)
Mel[o]stem™ MBAL Soin divin
SE0236C
SPLR % W/W to 100 0.10
4 0.60 0.80 0.04 13.00 5.00 3.00
6 0.70 7 0.30 1 1 1
3 1.00
2 1.00 2 3.00 5 0.10
Procedure: Weigh Part A. Weigh Part B and mix well. Part A: Adjust pH =5.50+/-0.10 with Part B, mix well. Weigh and heat Part A+B to 90°C in bain-marie with helix stirring. Weigh Part C and mix well. Add slowly Part C to Part A with normal helix stirring at 90°C in bain-marie. Allow Part A+B+C heating at 90°C for 1 hour in bain-marie with helix stirring. Weigh and heat Part D to 90°C in bain-marie. Add Part D into the previous part with strong helix stirring. Weigh and add Part E into the previous part and mix well with rapid helix stirring. Add Part F and mix well with rapid helix stirring. Out of the bain-marie add Part G and mix well with rapid helix stirring (s=450 rpm); Add Part H and mix well with rapid helix stirring (s=450 rpm) Pour into moulds immediately. Allow to cool for 15 minutes at room temperature. Properties: Appearance: Beige opaque gel block Stability: 3 months at 4°C, 25°C, 45°C and 1 month at 50°C Centrifuge 10min @ 3000rpm and 1 x -80ºC/+25ºC 24 hours freeze-thaw cycle and autoclave 20min @120°C
Suppliers: 1. Croda 2: Sederma 3: Crodarom 4: Alban Muller 5 : Parf’ex 6: CP-Kelco 7: Jungbunzlaeur
Procedure: Weigh phases A and C separately and heat up to 80°C. When both phases are at the right temperature, add B into A and stir with a spatula. Add phase C into (A+B). Add D just before emulsification. Emulsify for 4 minutes at 4000 rpm under Silverson. Cool down under anchor for 10 minutes + 10 minutes with a cold water bath. Disperse Sepifine BB in 5% of water. Add each component of E separately at around 40°C. Adjust pH at the end of the process. Properties: pH: 5.5 Viscosities: 1M at RT: 18,440 mPa.s Brookfield LV3-6 / Recovery at RT (after 1M at 45°C): 16,720 mPa.s Brookfield LV3-6. Stability: 3M at RT, 45°C.
TRI-K MOISTURIZING EUCALYPTUS FOAMING FACIAL WASH
PHASE INGREDIENTS A Water
BioPure™ GLDA
C Galaxy CAPB SB Galsoft SCGL Galsoft SCT-40
10.00 3.00 3.00
D Citric Acid E HyaClear® 7
Biochemica® Eucalyptus Oil
INCI NAME Water
Tetrasodium Glutamate Diacetate
B Glycerin 99.5% USP Glycerin Keltrol® CG-SFT
Xanthan Gum
Cocamidopropyl Betaine Disodium Cocoyl Glutamate Sodium Methyl Cocoyl Taurate Citric Acid
Water, 1,2-Hexanediol, Sodium Hyaluronate
Eucalyptus Globulus Leaf Oil
Unicert Blue 05601-J CI42090/ Blue 1 (0.1% Solution) TRIstat PCG 90
Phenoxyethanol, Caprylyl Glycol
SG 5-73
SPLR % W/W 69.95
1 0.10 2 3.00 3 0.40 4 10.00 4 8.00 4 6.00 5 0.30
6 1.00 7 0.15
8 0.10 6 1.00
Procedure: Combine phase A at room temperature until uniform. Premix Phase B, add to batch and heat Phase A/B to 80°C. Add phase C one at a time until fully dissolved and uniform at 75-80°C. Cool the batch to 40°C. Adjust the pH of the batch with Phase D as needed to 5.0-5.5. Add phase E ingredients one at a time. Cool to room temperature. Readjust pH if needed.
Suppliers: 1. Jarchem Industries, Inc. 2. Protameen Chemicals Inc. 3. CP Kelco 4. Galaxy Surfactants Ltd. Industries, Inc. 7. Hallstar 8. Sensient Cosmetic Technologies
ZSCHIMMER & SCHWARZ
“INTO THE GLOW” BODY OIL WITH GLITTER PHASE INGREDIENTS
INCI NAME
A ZETEMOL 99 ZETEMOL 518 ZETEMOL OE
Sweet Almond Oil B Uvinul MC 80
DL-a-Tocopheryl Acetate
SEPPIC
WELL: WASTE LESS LOTION PHASE INGREDIENTS/ INCI NAME
A Montanov™ 202 Lanol 2681
Emogreen™ L15
B Solagum™ AX Solagum™ Tara
C Aqua/Water D Hydralixir™ LD
PERSONAL CARE November 2023
% W/W 2.00 7.50 7.50 1.00 0.10
up to 100
5.00 Perfume
Sachet Interference Gold S2111
Isononyl Isononanoate Isostearyl Neopentanoate Dicaprylyl Ether
Prunus Amygdalus Dulcis (Sweet Almond) Oil
Ethylhexyl Methoxycinnamate Tocopheryl Acetate Parfum (Fragrance)
Synthetic Fluorphlogopite, Titanium Dioxide (CI77891), Tin Oxide (CI77861)
SPLR % W/W 1 46.50 1 1
26.00 23.50
2.50
2 0.20 3 0.20 0.60
4 0.50
Procedure: Following the indicated order, mix phase A while stirring until all ingredients are completely dissolved. Add phase B to phase A and stir to clearness and homogeneity. Add phase C and stir for 5 minutes. Properties: Stability: Stable for at least 12 weeks at 45 °C. Stable for at least 12 weeks at 5 °C. Stable for at least 12 weeks at room temperature. Viscosity: N.D. pH value: N.D.
Suppliers: 1. Z&S 2. BASF 3. DSM 4. Sandream Impact 5. Astro Chemicals 6. TRI-K
www.personalcaremagazine.com
Page 1 |
Page 2 |
Page 3 |
Page 4 |
Page 5 |
Page 6 |
Page 7 |
Page 8 |
Page 9 |
Page 10 |
Page 11 |
Page 12 |
Page 13 |
Page 14 |
Page 15 |
Page 16 |
Page 17 |
Page 18 |
Page 19 |
Page 20 |
Page 21 |
Page 22 |
Page 23 |
Page 24 |
Page 25 |
Page 26 |
Page 27 |
Page 28 |
Page 29 |
Page 30 |
Page 31 |
Page 32 |
Page 33 |
Page 34 |
Page 35 |
Page 36 |
Page 37 |
Page 38 |
Page 39 |
Page 40 |
Page 41 |
Page 42 |
Page 43 |
Page 44 |
Page 45 |
Page 46 |
Page 47 |
Page 48 |
Page 49 |
Page 50 |
Page 51 |
Page 52 |
Page 53 |
Page 54 |
Page 55 |
Page 56 |
Page 57 |
Page 58 |
Page 59 |
Page 60 |
Page 61 |
Page 62 |
Page 63 |
Page 64 |
Page 65 |
Page 66 |
Page 67 |
Page 68 |
Page 69 |
Page 70 |
Page 71 |
Page 72 |
Page 73 |
Page 74 |
Page 75 |
Page 76 |
Page 77 |
Page 78 |
Page 79 |
Page 80 |
Page 81 |
Page 82 |
Page 83 |
Page 84 |
Page 85 |
Page 86 |
Page 87 |
Page 88 |
Page 89 |
Page 90 |
Page 91 |
Page 92
