This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
So, here we go with the adapter plate. There will be lots of careful measuring and calculation required to ensure everything is square, concentric and manufactured to acceptable tolerances for reliable operation and long component life. I find it always helps to write everything down and make full-size sketches and drawings on a large sheet of graph paper. Here's my temporary 'drawing board'
- just half a sheet of ply, cable-tied to the back of the chassis. A few simple and inexpensive tools will be sufficient for the design and drawing job. A Digital Caliper can be accurate to within one thousandth of an inch or 0.01mm and can measure dimensions up to 150mm. And a selection of steel rules are cheap and accurate 'straight edges' and can give you instant measurements with an accuracy of less than half a millimetre - depending on your eyesight, of course.
To order Tel: 01580 891309 or 07964 336183 or Fax: 01580 893733 or online at www.cbsonline.co.uk