This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
INDICATOR STALK ASSEMBLY CHROME has built-in Hazard switch with red warning light and left & right green indicator lights. 600mm wiring harness and fuse. Will fit up to 56mm diameter column. Body size 85mm x 60mm x 60mm. Overall length 190mm. (not incl. clip) #INDCH £16 (£19.20 inc vat)
ONLINE
360° VIEW
COLUMN MOUNT INDICATOR SWITCH Simple column mounted indicator switch. Tidy, plated steel adjustable clamping band for up to 40mm column diameter. Chromed brass stalk with black moulded end. Length from centre of column to end of stalk 175mm. Old fashioned Bakelite construction. #INDSW3 £22 (£26.40 inc vat)
ONLINE
360° VIEW
WITH FLASHING GREEN END Same specification as above but with built-in indicator warning light. #INDSW7 £28 (£33.60 inc vat)
LATEST REVISION JULY 2011
PLEASE IGNORE PREVIOUS DIAGRAMS
INSTALLATION INSTRUCTIONS These switches are manufactured from a Bakelite material
NOT USED FOR UK SPEC. WIRING
BODY OF SWITCH MUST BE EARTHED
as authentic copies of the, now unavailable, original Lucas switches. So, like the originals they are relatively fragile and it is important they are handled carefully and installed correctly.
PERMANENT 12V +
ELECTRONIC FLASHER UNIT Ideal for our #INDCH. #ERLY3 £12 (£14.40 inc vat)
The adjustable clamping band is tensioned by tightening two slotted brass screws that are hidden under the removable face plate. Remove the faceplate and pull out the switch block. Choose a flat screwdriver that is the perfect size for the screw slots and loosen the screws as far as they will go without releasing the clamping band. Form the band around your steering column and hook the two halves together in the tightest possible position. Now re-tighten the screws evenly until the body and clamping band are firmly held around the column. DO NOT OVERTIGHTEN THE SCREWS. You can now feed the wires into the switch through the little cut-out in the switch body, next to the column and connect them to the switch block. Re-insert the switch block and refit the cover. AGAIN, DO NOT OVERTIGHTEN THE SCREWS.
CUT-OUT FOR
WIRES
To order Tel: 01580 891309 or 07964 336183 or Fax: 01580 893733 or online at www.cbsonline.co.uk