This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
PEDAL BOX - HYDRAULIC CLUTCH WITH INTEGRAL THROTTLE PEDAL Here's a black powder-coated floor- mounted pedal box. Nicely made from 2.7mm and 5mm steel. The clutch pedal has a 6 to 1 ratio and the brake pedal has 4.75 to 1. Both brake and clutch pedals pivot on nylon bushes. The bottom half of the throttle pedal (below the pivot point) has a maximum of 50mm movement. No holes are made for throttle cable or it's connection to the pedal. Three 37mm holes for master cylinders. All of our standard, Integral Reservoir and Non-Reservoir cylinders will fit although the push rods may require shortening. The 26mm I.D. balance bar tube is cleverly offset towards the front brakes cylinder to centralise the bearing inside the tube when the balance bar is biased in favour of the front brakes. This may mean that the front brake cylinder push rod is angled slightly. This is OK and is within the cylinder design parameters. No floor fixing holes are drilled. NOTE: SUPPLIED EXACTLY AS SHOWN IN THE PICTURE BELOW. CYLINDERS AND BALANCE BAR ARE NOT INCLUDED. #PEDBOX2 £110 (£132 inc vat) .
68mm 63mm
PEDAL BOX DEAL WITH CYLINDERS, CLUTCH CLEVIS AND BALANCE BAR KIT Included in this deal are: Your choice of 3 master cylinders from our range: #MA625, MA625I, MA7, MA7I, MA75 or MA75I Balance Bar #BBAR Balance Bar Adjuster Cable #BBADJ Clutch Clevis #CLEVIS Non Slip Tape #NOSLP
INDIVIDUAL TOTAL PRICE WOULD BE £255.50 (£306.60 inc vat) DEAL PRICE #PBDEAL £220 (£264 inc vat)
NO FURTHER DISCOUNTS ARE AVAILABLE ON THIS DEAL
ONLINE
360° VIEW
Clutch
Front brakes
Rear brakes
280mm 250mm
130mm
240mm To order Tel: 01580 891309 or 07964 336183 or Fax: 01580 893733 or online at www.cbsonline.co.uk ISSUE 26 Page 11