This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
FUEL PUMP This excellent quality pump is now available in two versions. One (#FPUMPS) is a 'Suction' version best used for installation in your engine bay. The other (#FPUMP) is a 'Pressure' version for mounting near the fuel tank. 12 Volt. Flow rate 125 Lt/hr. Integral 8mm swivelling inlet & outlet unions. Size 73mm x 128mm. Mounting bracket & fixing screws included. Made in Germany.
Not suitable for Bio Diesel. ECE Approved NOTE: We always recommend the use of a pre-filter with all fuel pumps. #FPUMP Pressure 4.2 psi. Suction -1.4 psi. £68 (£81.60 inc vat) #FPUMPS Pressure 2.1 psi. Suction -2.8 psi. £68 (£81.60 inc vat)
The fuel pumps on this and the following page are suitable for carburettor engines. They are OK for petrol, diesel and alcohol fuels with all additives. All have a built in anti-siphon and anti drain-back valves. Simple two bolt installation. For best results mount as close to the fuel tank as possible below the fuel level and always use a filter between the tank and pump. Rubber mountings are recommended (see our mounts section)
ANODISED ALUMINIUM CABLE OR HOSE SEPARATORS For tidying and separating electrical or HT cables, pipes, hoses or control cables. Weight 12 gms.
2 WAY 8mm SILVER #CSEP28S £4.50 each (£5.40 inc vat)
2 WAY 8mm RED #CSEP28R £4.50 each (£5.40 inc vat) ONLINE
360° VIEW
2 WAY 8mm BLUE #CSEP28BU £4.50 each (£5.40 inc vat)
3 WAY 8mm GUNMETAL #CSEP38G £5.50 each (£6.60 inc vat)
GREAT ONLINE SHIPPING DEALS
IF YOU ORDER ONLINE, COURIER DELIVERY TO UK MAINLAND
IS ONLY £6 + vat ore
FREE
IF YOU SPEND OVER £100 (not inc. vat)
Page 76 To order Tel: 01580 891309 or 07964 336183 or Fax: 01580 893733 ISSUE 27
4 WAY 8mm GUNMETAL #CSEP48G £5.50 each (£6.60 inc vat)