This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
FAN SWITCH M14 x 1.5 thread. For use with a relay or our own accessory wiring kit. ¼" Spade connections. On at 87ºC and off at 82ºC #FANSW £12 (£14.20 inc vat) On at 97ºC and off at 85ºC #FANSW4 £12 (£14.20 inc vat) On at 100ºC and off at 95ºC #FANSW2 £12 (£14.20 inc vat) On at 107ºC and off at 97ºC #FANSW3 £12 (£14.20 inc vat)
Just cut your hose and insert the housing. Beautifully cnc’d aluminium. M10 x 1 thread and earthing screw. Multiple uses: •
• •
IN-LINE COOLANT HOUSINGS
Electronic water temp gauge sender using the standard M10 x 1 thread and earth screw. We can re- tap the thread to match your sender for £5.
Air bleed or coolant drain in top or bottom hose using an M10 x 1 Blanking Plug or short bolt.
Air bleed back to your header tank using a M10 threaded hose-tail.
• We can re-tap the thread to accept our fan switch. Fits hose I.D. size: 25mm #INT25, 32mm #INT32, 38mm #INT38 All £15 each (£18 inc vat)
Other threads machined on request. £5 extra. (£6 inc vat)
FAN SWITCH M22 x 1.5 thread. ¼" Spade connections. 30mm A/F Hex. Weight 60 gms. On at 95ºC and off at 86ºC #FANSW5 £12 (£14.20 inc vat) On at 88ºC and off at 79ºC #FANSW6 £12 (£14.20 inc vat) On at 82ºC and off at 72ºC #FANSW8 £12 (£14.20 inc vat)
ONLINE
360° VIEW
MULTI PURPOSE
GAUGE TEMP SENDER
SURFACE MOUNT FAN SWITCH ON AT 100ºC OFF AT 82ºC Here's a tiny temperature switch that you can rivet, bolt or even Cable-Tie to a flat surface. 1 amp contact rating so it must b e used with a relay. 1/4" spade terminals. Two, 3.5mm fixing holes at 24mm centres. Weight 10 gms.
#FANSW7 £16 (£19.20 inc vat)
AIR BLEED TO HEADER TANK
FAN SWITCH
EARTH SCREW FOR SINGLE WIRE SENDERS
MODULAR INLINE HOUSINGS A new range of machined natural aluminium in-line coolant housings for temperature senders or fan switches. Two housing sizes are available to fit 32mm I.D. hose and 38mm I.D. hose. Both have a female M22 x 1.5 thread that will accept a standard M22 fan temp switch from our range. See plumbing section for more details.
ONLINE
360° VIEW
PTFE TAPE General thread sealing tape ideal for oil, air and water fit- tings. 12mm wide x 10 metres roll. #PTFE £1 (£1.20 inc vat)
#FANSW #INSM14 #MOIN38
To order Tel: 01580 891309 or 07964 336183 or Fax: 01580 893733 or online at www.cbsonline.co.uk