This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
HOUSING FOR 125mm DIAMETER LAMPS Gloss Black moulded ABS housing for 125mm diameter rear lamps. Shown below with a #RL53. Moulded from 2mm thick ABS sheet it's mounting face diameter is 130mm. This means that a 125mm diameter lamp will sit micely on the edge of the moulding radius. The height of the housing is 60mm so you can trim it to mount on an angled rear panel up to 20º off vertical. Housing is shown drilled for a #RL53 but will be supplied undrilled. MOUNTING TIPS: The trimmed edge can be fitted with our #TRMU2 rubber edging trim giving a good contact point with your panel. The housing can be mounted with long studs and / or spacing tubes through the panel. #HOU125 £8 each (£9.60 inc vat)
CONTROL CABLE - SALE ITEM - NO RETURN Here's a heavy duty cable that can be suitable for hand- brakes or clutch. Multi-strand inner cable 1170mm long, diameter 3.5mm with a 8mm hex nipple on each end. Outer cable 1050mm long, diameter 10.5mm. Rubber moisture seal on each end. Maximum travel of inner 92mm. #CONCAB2 £8 (£9.60 inc vat)
NOTE: SALE ITEM - NO RETURNS
11.6mm
Angle 140º
13.9mm
CONTROL CABLE - SALE ITEM - NO RETURNS Here's a heavy duty cable that can be suitable for hand- brakes or clutch. Multi-strand inner cable 1110mm long, diameter 3.5mm with a 8mm hex nipple on each end. Outer cable 1000mm long, diameter 10.5mm. Rubber moisture seal on each end. Maximum travel of inner 55mm. #CONCAB3 £8 (£9.60 inc vat)
NOTE: SALE ITEM - NO RETURNS
13.9mm
Angle 170º
11.6mm
Page 550
To order Tel: 01580 891309 or 07964 336183 or Fax: 01580 893733