This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
HARNESS MOUNTING PLATE Plated steel backing plate 52mm x 25mm x 6mm thick. Tapped 7/16" UNF. Each plate has a drilled 6.4mm hole for mounting the plate. #716RP2 £2 (£2.40 inc vat)
FIA HARNESS FIXING PLATE FIA - approved, plated steel reinforcing / backing plate with a welded 7/16" UNF nut for seat belt mounting points. 65mm x 65mm x 3mm thick. There is a 5mm drilled location hole in one corner. #716RP3 £2.50 each (£3 inc vat)
LOCKING BONNET PIN KIT FItting Instructions:
1. When you are determining the mounting position for the locking bonnet pins bear in mind the critical dimension requirement of 3/4" (19mm) from the top of the striker bolt to the top of the bonnet in it's closed position. The lock and bolt mounting surfaces must also be parallel to ensure accurate alignment and correct operation of the lock. If these conditions cannot be met you may need to fabricate a mounting bracket for the striker bolt.
2. Drill a 3/4" (19mm) hole for the lock and a 3/8" (10mm) hole for the bolt.
3. Install the lock, stainless plate and rubber gasket from the outside of the bonnet and the grey, locking plate on the inside. (Note: You may wish to deburr the stainless plate before fitting.)
4. Install the striker bolt and adjust it's height to achieve 3/4" (19mm) from the top of the bolt to the outer skin of the closed bonnet. #BPLOC £16 pair (£19.20 inc vat)
IMPORTANT NOTE
WE RECOMMEND THAT THIS PRODUCT BE USED IN CONJUNCTION WITH THE MANUFACTURERS ORIGINAL BONNET SAFETY CATCH
To order Tel: 01580 891309 or 07964 336183 or Fax: 01580 893733 or online at www.cbsonline.co.uk ISSUE 27 Page 511