This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
SLIDE LATCH STAINLESS STEEL This neat little Stainless Steel Slide latch consists of a sliding plate assembly, a 'cotton-reel' bush and two spacer washers. The sliding latch assembly is attached to the hinged or removable panel and the bush is mounted to the fixed panel below. When the lid or panel is closed, sliding section is slid along, locating around the bush to resist opening under vibration and shock loads. Washers can be installed under the bush to accommodate different panel thicknesses. #SLSS £6 (£7.20 inc vat)e
ONLINE
360° VIEW
SLIDE LATCH ABS This neat little Plastic Slide Latch is a one piece moulding with a clean, flush appearance that mounts through a rectangular hole in a lid or removable panel. It is held in place on the underside of the panel by a separate, push-on 'U'-shaped retainer. Three different thickness retainers are available depending on the panel thickness. The rectangular hole in the panel is cut to allow the latch to slide to and fro to release or engage the pawl. A hidden, stainless steel spring is nested at the back end of the one-piece latch body, and contacts the back edge of the panel hole. This ensures that the latch is always held in the closed position. When the panel is pushed closed, the sloped pawl edge meets the lower panel which pushes the latch back. As the panel closes fully, the pawl clears the lower panel and the spring pushed the latch forward to the closed position. Sliding the latch back with a finger opens the panel. The panel hole is always hidden. Recommended pawl latching overlap ¼" (6mm). LATCH #SLABS £4 (£4.80 inc vat) SNAP CLIP RETAINER #SCRET1 (2) or (3) £0.60 (£0.72 inc vat) Select the appropriate snap clip retainer from the table ac- commodates panel thickness from .043" to .083" (1.09 to 2.11 mm).
BUSH INSTALLATION OPTIONS The Bush can be secured in many different ways. Washers or spacers under the bush will adjust it's height for different panel thicknesses.