This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
FUEL GAUGE KIT 50mm illuminated instrument, 55mm deep with matching adjustable float sender that fits through a 38mm hole in your fuel tank. Sender flange diameter 70mm. Fixing hole PCD 54mm. Supplied with gasket, fixing screws and full fitting instructions. Illuminated. 12 volt. #FUGA £42 (£50.40 inc vat)
FUEL LEVEL SENDER ONLY Adjustable float sender that fits through a 43mm hole in your fuel tank. Sender flange diameter 75mm. Six 5.4mm fixing holes at 60mm PCD. Supplied with gasket. The 2mm diameter wire float arm comes in two halves which can be bent, cut and joined with the ring-crimps supplied. We recommend that, once you have set the float arm length, you solder the two wire halves together. Float arm travel 75 degrees. Float arm length adjustable between 150mm and 600mm. Minimum fuel tank depth 200mm. 1/4" spade terminal connections. 250 ohm resistance. Please check suitability with your instrument before purchasing. If the sender resistance does not match your gauge you may not get accurate readings. #FUSEND2 £20 (£24 inc vat)
MINIMUM
TANK DEPTH 200mm
but can be side mounted
ELECTRONIC FUEL GAUGE MATCHER This clever little device is designed to make a better match between non- matching fuel senders and fuel gauges. Simply connect between the sender and gauge and follow the instructions to calibrate for the best match. There is even a function to smooth out the non-linear resistance of some older senders. Supplied with full instructions. Note: Unit can get quite warm during use so do not cover. Allow air to circulate around it. NOTE: The tiny PCB 'Jumper' is supplied loose inside the case. Size 58mm x 36mm x 22mm. #FGMATCH £32 (£38.40 inc vat)
FUEL TANK SENDER ONLY (As above) 250 ohm resistance. Adjustable float sender that fits through a 38mm hole in your fuel tank. Sender flange diameter 70mm. Fixing hole PCD 54mm. Supplied with gasket, fixing screws and full fitting instructions. Please check suitability with your instrument before purchasing. #FUSEND £25 (£30 inc vat)
ADAPTERS AVAILABLE
Page 194
REPLACEMENT BULB FOR DURITE GAUGES #GABULB £1.50 (£1.80 inc vat)
To order Tel: 01580 891309 or 07964 336183 or Fax: 01580 893733