This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
PLATED STEEL SELF-ASSEMBLY FLEXIBLE BRAKE PIPE FITTINGS Make your own flexible brake pipes with this range of self-assembly fittings. All have 7/16" AF and 1/2" AF Hex spanner sizes. All include a brass olive where appropriate. All seats machined at 90 degrees.
ASSEMBLY INSTRUCTIONS Cut the hose to length with sharp, heavy duty side cutters or snips. If the cut end has flattened slightly, reshape it with pliers.
First, push the tube nut over the braid, on to the hose. Using a pointed scriber or similar tool flare the braid away from the PTFE tube on the first 5mm of the tube.
STRAIGHT SWIVEL FEMALE CONCAVE SEAT M10 x 1mm. 35mm long.
Push the olive fully onto the PTFE hose ensuring that all the braids are on the outside of the olive. Insert the fitting spigot into the hose and screw the tube nut onto the fitting. Tighten with two spanners until the tube nut is almost tight against the fitting.