This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
ROTARY 2 SPEED WIPER SWITCH Nice quality. Nice action. 2 Speed wiper switch with 'Park' facility. Mounts through an 11mm hole. Two flats on mounting thread. Maximum panel thickness 6mm. Knob diameter 30mm. 1/4" Spade Terminals on rear. Rear projection 32mm. Switch body diameter 34mm. 16 Amp max. NOTE: Your wiper motor must have two-speed winding and park facility for this switch to work correctly.
WIRING: B = +12 volts in. L = Low Speed out. H = High Speed Out. P = Park #WIPSW2 £12 (£14.40 inc vat)
WIPER SPARES
WIPER WHEELBOX 45 DEGREE WEDGES We've finally managed to procure these seperately. Hard rubber, angled sleeves that fit over you wiper wheelbox shaft and allow you to angle the wheelbox at 45º through your scuttle. NOTE: You may require two per wheelbox for your installation. Available in two sizes: SMALL 24mm diameter, 16mm I.D. Maximum length 25mm #WBWEDGS £2.50 (£3 inc vat)
LARGE 27mm diameter, 16mm I.D. Maximum length 24mm #WBWEDGL £2.50 (£3 inc vat)
CHANGE-OVER RELAY #RLY5CO
1
3 2 5 4
WIPER MOTOR PLUG
30
86
87a 87 85
CHROME PLATED WIPER WHEELBOX NUT
#WIPSW2 L H
+ LIVE FEED
B P
Octagonal nut 19mm (3/4") across the flats x 4.8mm thick. Thread 5/8" x 24 tpi UNEF #WBNUT £2.50 (£3 inc vat)
REPLACEMENT WIPER MOTOR PARK SWITCH For our wiper motors. #PARKSWITCH £12 (£14.40 inc vat)