This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
CHROME HEAD QUARTER TURN FASTENER WITH BACKING PLATE. These quarter-turn fasteners were designed for fixing together two, 2mm thick panels. The plate (receiver) is slid over the edge of the lower panel, secured with two rivets (supplied) and a clearance hole is drilled through the panel. A 6mm hole is drilled through the top panel and the fastener is pushed through and twisted just a quarter of a turn, locking it in place. A rubber washer prevents vibration and protects the top panel's surface. If your panels are thinner than 2mm you can use 'Doublers' - small pieces of panel glued to the first to increase it's thickness. Chrome head diameter 12mm. Shaft diameter 6mm. Plate fixing hole centres 25mm. Hole centre distance from edge of lower panel 12mm. Distance from underside of rubber washer to end of shaft 14mm. CHROME HEAD FASTENER #CQT14 £2.50 each (£3 inc vat)
ONLINE
360° VIEW
DZUS FASTENERS
DOME HEAD DZUS FASTENER WITH SPRING. These quarter-turn fasteners offer probably the simplest method for securing panels with quarter-turn fasteners. Head diameter 14mm. Shaft diameter 7.7mm. Just drill an 8mm hole through the upper and lower panel and mount the spring to the bottom panel TO MAKE YOUR SELECTION: First measure the total thickness ('T') of the panels you wish to secure (see diagram below) and locate the dimension in the first column of the chart. Move along the same line to select the part number.
DOME HEAD FASTENER #DZDH £3.30 each (£3.96 inc vat)
G
TOTAL
MATERIAL THICKNESS INCH
IT'S HERE AT LAST. THE LONG-AWAITED SEQUEL TO OUR VERY SUCCESSFUL 'GETTING STARTED' DVD. THIS COULD BE THE BEST £12 YOU'LL EVER SPEND ON YOUR CAR #DVD2 £10 (£12 inc vat)