This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
TELEPHONE ORDERS ONLY We are often asked for switches and warning lights of all one colour so, for everyone who is not concerned with IVA you can now.....
CHOOSE THE BODY
CHOOSE THE BULB COLOUR CHOOSE THE LEGEND
ASSEMBLY INSTRUCTIONS
1. BULB. Drop the bulb, base first, down into the body recess locating it over the bulb contacts. Move it roughly in-line with your fingertip and press until it snaps into the contacts. To remove the bulb grip the lens gently with a small pair of needle-nose pliers and pull it out like a tooth. 2. LEGEND. Drop the legend housing down into the body, over the bulb and rotate it gently with your fingertips until the small slot in the legend housing locates over it's mating projection inside the body. You'll feel it when it does. A gentle push with one finger will snap the legend into place. To remove the legend, back off the threaded ring until the aluminium bezels drop below the surface of the legend. You can now grip it with your fingertips and pull it out. 3. CONTACT BLOCK Just push the contact block onto the switch body until it clicks into place. It can only go one way round.
DOUBLE POLE CONTACT BLOCK SINGLE POLE HAS ONE SIDE AND LED TERMINALS ONLY
Normally closed contact
3 2 +12v out A 1 +12v in 3
+ 12v LED Normally closed contact
DIM / BRIGHT WIRING KIT
It's now possible for these to have dimmed illumination in that comes on with your sidelights. Then, if you press the switch to activate the accessory, the illumination changes to full brightness. One per switch required. Wired easiest with double pole switch contact block but can be used with single pole block by piggy-backing to the switch +12v out terminal.#BSWDIM £3 each (£3.60 inc vat)
TO SWITCH + 12v OUT
FROM DASH ILLUMINATION +12v
TO ILLUMINATION TERMINAL 'A'
Page 126 To order Tel: 01580 891309 or 07964 336183 or Fax: 01580 893733 ISSUE 27 #BSLOIL #BSLBAT #BSLHORN #BSLSTART #BSLNEUT #BSLECU #BSLPKBRK #BSLBRKFL - 12v LED +12v in (EARTH) B 1 2 +12v out SINGLE POLE
CONTACT BLOCK Terminals as half the diagram on the left
LATCHING SWITCH SINGLE POLE #BSLSP DOUBLE POLE #BSLDP £12 each (£14.40 inc vat)
MOMENTARY SWITCH SINGLE POLE #BSMSP DOUBLE POLE #BSMDP £12 each (£14.40 inc vat)
WARNING LIGHT #BBL £9 each (£10.80 inc vat)
LED BULB COLOUR OPTIONS RED #BBR £4.50 each (£5.40 inc vat)
AMBER #BBA £4.50 each (£5.40 inc vat) BLUE #BBB £4.50 each (£5.40 inc vat) GREEN #BBG £4.50 each (£5.40 inc vat)