This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
HOUSING FOR 125mm DIAMETER LAMPS Gloss Black moulded ABS housing for 125mm diameter rear lamps. Shown below with a #RL53. Moulded from 2mm thick ABS sheet it's mounting face diameter is 130mm. This means that a 125mm diameter lamp will sit micely on the edge of the moulding radius. The height of the housing is 60mm so you can trim it to mount on an angled rear panel up to 20º off vertical. Housing is shown drilled for a #RL53 but will be supplied undrilled. MOUNTING TIPS: The trimmed edge can be fitted with our #TRMU2 rubber edging trim giving a good contact point with your panel. The housing can be mounted with long studs and / or spacing tubes through the panel. #HOU125 £8 each (£9.60 inc vat)
LOW PROFILE LED SURFACE MOUNT REAR LAMP 'E9' Marked. STOP, TAIL AND CLEAR-LENS INDICATOR Sealed-for-life on a thin white base. 140mm diameter. Front projection just 20mm. Fixes to rear panel with 3M double sided tape. Two 10mm diameter locating pegs at 80mm centres. 400mm long flylead. 12 or 24 volt. WIRING COLOURS: WHITE - Earth, YELLOW - Indicator, BROWN - Tail, RED - Stop. #RL97 £55 pair (£66 inc vat)
To order Tel: 01580 891309 or 07964 336183 or Fax: 01580 893733 or online at www.cbsonline.co.uk