This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
AIR SHEAR This air tool cuts a 5mm wide strip of material in straight cuts or gentle curves, from sheet aluminium, plastic or steel up to 18 gauge (1mm) with minimal distortion to either side. Operating and maintenance instructions included.
Air consumption 2.1 cfm Maximum air pressure 100 psi. 1/4" BSP air inlet connector union included. Weight 1160 gms. #AIRSHEAR £30 (£36 inc vat)
AIR CUT-OFF GRINDER There are loads of uses for this great-value air tool. From cutting stainless-braided hoses to trimming GRP panels or cutting metal pipes and tubes. Takes 75mm diameter x 2mm thick discs with 9.75mm bore. Comes with a clear plastic guard, spanner and hex key. Air inlet 1/4" BSP. Maximum air pressure 110psi. Work- ing pressure 90psi. Air consumption 4cfm. Length 245mm. Weight 670gm. #AIRCUTOFF £20 (£24 inc vat)
ONLINE
360° VIEW
AIR NIBBLER This air tool nibbles a 5mm wide track through sheet steel or aluminium up to 1.5mm thick with minimal distortion. It will cut intricate shapes by hand or straight lines along a template or edge. Air consumption 6 cfm Maximum air pressure 100 psi. 1/4" BSP air inlet connector union included. Weight 930 gms. #AIRNIBBLER £25 (£30 inc vat)
METAL CUTTING DISC 70mm dia. x 3mm thick, 10mm Hole. #D70X3 £1 each (£1.20 inc vat)
1mm CUTTING DISC. 76mm diameter x 1mm thick with a 10 mm hole. These discs are suitable for cutting stainless steel tube, pipe, bar and even our stainless braided hose (don't forget to wash it out before fitting). See the instructions in the Hints and Tips pages at the back of this catalogue. #D76X1 £2.50 each (£3 inc vat)
To order Tel: 01580 891309 or 07964 336183 or Fax: 01580 893733 or online at www.cbsonline.co.uk