This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
GT MIRROR Here's a stylish, period mirror made from moulded plastic. 160mm high from base to top of glass. Glass diameter 104mm. Base size 90mm x 30mm with a single M8 bolt fixing. Loosen the single pozi screw in the base and the stem can be rocked left and right on the base up to 180 degrees. Loosen the glass housing by rotating it anticlockwise and it can be angled in relation to the head. Flat glass. #M19BK £12 pair (£14.40 inc vat)
ONLINE
360° VIEW
CHROME PEDESTAL MIRROR Tough, chromed plastic housing for flat glass - size 135mm x 98mm. Base gasket footprint 152mm x 31mm. Base mounting plate has 2 screw fixing Through rubber mounting gasket. Will fit existing hole centres between 35mm and 120mm. Chromed, diacast alloy pedestal has single screw fixing to base plate. 30 degrees angular glass movement. #M12PD £20 pair (£24 inc vat)
S P ECI F ICAT ION UPDAT ED
STAINLESS STEEL WING OR DOOR MIRROR Glass surround, housing, spherical joint and mounting foot all made from polished stainless steel. Mounting plate inside the foot is galvanised steel. Supplied with a nice quality rubber gasket and stainless steel M5 fixing screws and nuts. relative to the head. Flat glass 112mm dia. Foot size 120mm x 40mm. 2 screw fixing. (supplied) Will fit existing hole centres between 30mm and 50mm. Maximum height 120mm. Glass housing can rotate 360 degrees on the foot and has approximately 25 degrees of angular movement. #MSSRND £18 each (£21.60 inc vat)
ONLINE
360° VIEW
CHROME PEDESTAL MIRROR Tough, round, chromed plastic glass housing - size 120mm dia. rotates 360 degrees and has 45 degrees angular movement on spherical mount. Flat glass. Base gasket footprint 160mm x 30mm. Base mounting plate has 2 screw fixing. Will fit existing hole centres between 35mm and 120mm. Moulded plastic gasket. Chromed, diacast alloy pedestal has single screw fixing to base plate. #M22PD £20 pair (£24 inc vat)
ONLINE
360° VIEW
ONLINE
360° VIEW
BUILDERS TIP If you’re mounting a flat mirror base to a curved surface it’s easy to build-up the mirror base to a perfectly matched curve using body filler. First drill the mounting holes in the body. Then apply sellotape over the mounting area to act as a mould release. Key the mirror base with some coarse wet & Dry then bolt on the mirror (without the gasket) and support it in the correct position. Fill the gap with filler. Dress off the excess and paint to match.
Page 282
DIMENSIONS CONVERSION CHART IN BACK PAGES
To order Tel: 01580 891309 or 07964 336183 or Fax: 01580 893733 ISSUE 27