Compressor Overloads & Start Assists

PRO-SERIES MOTOR PROTECTOR

MARS Motor Protector solve the problem of finding suitable replacements for motor overloads protectors. These overloads will replace most standard overloads on 1/20th thru 1/2 HP at 115V and 1/12th thru 1 HP at 230V. Used in refrigeration, room air condi- tioners, refrigerators, freezers and motors. Each overload has 6” leads and two wire nuts for simple installation.

CAT. NO. MFG. NO. EACH 3R816 3R817 3R818 3R819 3R820 3R821 3R822 3R823 3R824 3R825

35001 35002 35003 35004 35005 35006 35007 35008 35009 35010

$18.26 $18.26 $18.26 $18.26 $18.26 $18.26 $16.08 $18.26 $17.76 $17.22

CAT. NO. MFG. NO. EACH 3R831 3R832 3R834 3R835 3R836 3R837 3R838 3R839 3R840

35011 35012 35014 35015 35016 35017 35018 35019 35020

$18.26 $18.26 $18.26 $17.22 $17.22 $17.22 $17.22 $17.22 $17.22

PTC START ASSIST KITS

Intended for use as a starting assist for PSC air conditioning com- pressors. This kit utilizes a positive temperature coefficient solid state material which when wired in parallel with the run capacitor of a PSC motor, provides additional starting torque. PTC device re- quires a 3 minute cool-down period before recycling and therefore cannot be used on a system wired for capacitor off-cycle crankcase heat.

CAT. NO. MFG. NO. EACH 6Z8900

3 Terminal $89.65

Kickstart® HARD START DEVICES MARS NO.

35001 35003 35004 35005 35006 35007 35008 35009 35010

35011 35012 35013 35014 35015 35016 35017 35018 35019 35020

Note: The guide is for “Quick Selection” only. Refer to manufacturers’ cross reference by part number for exact replacements.

110/115V

QUICK GUIDE HORSEPOWER

1/20 1/12 1/8 1/6 1/5 1/4 1/3 1/2

With OEM approval for permanent installation. Approved by Ducane, Goodman and York to re- place original equipment manufacturers start kits.

208/240V 1/12 1/8 1/6 1/5 1/4 1/3 1/2 1

For single phase 208v to 265v A/C, refrigeration and heat pump compressors. Kickstart® hard start devices utilize a start capaci- tor/potential relay combination to allow air conditioning and heat pump compressors to start with maximum efficiency thus reach- ing normal rated speed at up to 10 times faster than compressors without hard start device installed.

CAT. NO. MFG. NO. USE WITH: EACH 8G8911 8G8912

TO-5 KS1

1 to 3 HP 3.5 to 5 HP

$90.44 $81.94

HEAT PUMP DEFROST TIMER

Electro-mechanical defrost timer for time initiated/ time or temperature terminated applications. Provides 10 minute defrost periods at 45 or 90 minute select- able intervals; 2-SPST switches, 240v AC operation. Exact replacement for General Electric and Paragon controls used as original equipment on Carrier, Bryant and Trane heat pumps.

CAT. NO. MFG. NO. EACH 3R813

34790 $92.61

784

CONTROLS