RESIDENTIAL ENERGY SAVER DOUBLE-WALL INDIRECT WATER HEATER ON TANK RESIDENTIAL APPLICATIONS ON PARTS RESIDENTIAL APPLICATIONS

The PowerStor2™ series indirect water heater features a 1-1/2” OD double wall Vitraglas® steel heat exchanger coil. The positive leak path between the walls of the coil ensures potable water separation from the hydronic fluid. Additional features include factory Hydrojet Total Perfor- mance system, to minimize sediment build up in the tank. 2” non-cfc foam insulation to reduce standby heat loss, fully automatic fast acting surface mounted thermostat, two protective anode rods, temperature/pressure relief valve and brass drain valve. Domestic water connections are 3/4” NPT. Boiler water connections are 3/4” NPT. Heaters are tested at 300 PSI and rated for 150 PSI operating pressure.

CAT. NO. MFG. NO. CAPACITY GALLONS

5H964M DW-2-40-L 38

DIMENSIONS DIA x HEIGHT

22” x 41”

1ST HOUR DEL @ 135°F

123 gal.

CONT DRAW @ 135°F

MIN HEAT REQUIRED

MIN HEAT SOURCE FLOW RATE

98 gal. 65,000 btu 8.0 gpm WEIGHT EACH 170 lbs $2,535.28

PowerStor2™

RESIDENTIAL ENERGY SAVER - GAS DIRECT VENT WATER HEATERS

Availability of ICON System models subject to inventory.

ON TANK ON PARTS

High efficiency, high recovery water heater with closed combustion draws combustion air from outside, making this an ideal choice for modern, tightly insulated homes. Sidewall vent design works well for multi-story applications such as apartments and condos. Features Vitraglass® lined tank and special anode rod for maximum corrosion protection. Standard features include 1” non-CFC foam insulation, Hydrojet® turbulator system, factory included pressure/temperature relief valve, the Bradford White ICON System™, with factory preset balance pressure regulator and built-in energy cutoff (ECO), and brass drain valve. Heat Traps factory installed, minimizes heat loss through piping.

All models are shipped with a standard vent kit which allow 24” distance from water heater side to thru-wall vent terminal. Accessory kit listed below allows increase of water heater-to-vent terminal distance. Optional kits are also available for extensions of 4” to 14” and up to 8 feet. Bradford White Extended Service Agreements are available for these water heaters.

CAT. NO. MFG. NO.

TANK CAPACITY

9W160NA DS-1-40S6FBN 40 gal. 9W160PA DS-1-40S6FSX 40 gal. 9W162NAB DS1-50S6FBN 50 gal. 9W162PA DS1-50S6FSX 50 gal.

Note: Height is to top of the heater CAT. NO. MFG. NO. DESCRIPTION EACH 9W164 243-41029-00 Vent Kit Extension for up to 48” $135.12

GAS BTUH INPUT

RECOVERY @ 90° RISE

Nat. 38,000 41 LP 36,000 39 Nat. 42,000 45 LP 40,000 43

DIMENSIONS HEIGHT 49-3/4” 49-3/4” 58-3/4” 58-3/4”

DIMENSIONS DIAMETER 20” 20” 20” 20”

WEIGHT EACH

169 lbs. $1,502.33 169 lbs. $1,613.34 186 lbs $1,563.75 186 lbs $1,658.22

Visit us at www.remichel.com

403

WATER HEATING EQUIPMENT