C7012E Series ULTRAVIOLET FLAME DETECTOR

Solid state electronic flame sensing detector for sensing ultraviolet radiation produced by combustion. C7012E is only for use with Dynamic Self-Check systems.

CAT. NO. MFG. NO. 2C966

C7012E1104

VOLTAGE EACH 120

$4,072.80

C7008A Series FLAME ROD AND HOLDER ASSEMBLY

A miniature “spark plug: type flame rod holder with flame rod. Flame rods may be cut to any desired length. Threaded mounting base. Rajah electrical connector. Snap-on cover protects electrical connection.

CAT. NO. MFG. NO. 2C965 2C967

C7027A Series ULTRAVIOLET FLAME DETECTOR

Detects ultraviolet radiation from the flame of gas, oil, coal or combination burners. Use with RA890G, R4795, R4126, R4127, R4138, R4140, R4150. Mounts on 1/2” pipe. Six ft. lead length.

CAT. NO. MFG. NO. 2C968 2C959

C7027A1031 C7027A1049

AMBIENT TEMP. RANGE EACH -40°F to 215°F 0°F to 215°F

$240.64 $199.13

FLAME SAFEGUARD TEST METER

A versatile electrical test meter to check operating characteristics of flame safeguard systems. The meter contains a selector switch with five positions: Off (meter not in use), 300V AC (checking line voltage

C7035A Series ULTRAVIOLET FLAME DETECTOR

Detects ultraviolet radiation from the flame of gas, oil coal or com- bination burners. Use with R890G, R4795, R4126, R4127, R4138, R4140, R4150. Mounts on 1” pipe. Six ft. lead length. 129464N sensing tube available as a replacement part.

CAT. NO. MFG. NO. 2C969

C7035A1031 129464N

AMBIENT TEMP. RANGE EACH -40°F to 250°F

CAT. NO. MFG. NO. DESCRIPTION 2C831

EACH Replacement sensing tube $465.73 $460.30

and other AC voltages), 150V DC (checking DC voltages such as flame-relay voltage), 25 UA (checking flame-signal current on sys- tems using rectifying flamerod, rectifying photocell, or Ultra - Vi- sion* flame detectors), and SPL (checking flame signal current on systems using a intermittent rectification-type signal). Plastic case with hinged cover and latch; compartment for leads and adapters. Dimensions: 7” length, 5” width and 2-1/4” depth.

CAT. NO. MFG. NO. EACH 2C987

W136A $609.88 DESCRIPTION

C7008A1182 C7008A1174

Holder w/24” Flame Rod Holder w/12” Flame Rod

EACH

$303.95 $239.56

R7795 Series SOLID STATE

PRIMARY CONTROLS C7015 Series INFRARED FLAME DETECTOR

Combination mount and 104662D medium sen- sitivity plug-in lead sulfide cell senses infrared

radiation from pilot and/or main flame. Flexible 30” lead makes it ideal for where flame rods or photocell mounts are difficult to apply. Mounts on 3/4” pipe. Leads-sulfide cells are available for replacement as listed below.

CAT. NO. MFG. NO. 1C585 2C845

DESCRIPTION

C7015A1076 104662D

Photocell mount w/104662D Photocell, maximum sensitivity (white) EACH

$435.68 $268.04

Solid state primary control provides electronic flame safeguard protection for commercial and

industrial single or dual-fuel burners. Allows field selection of re- cycle or lockout upon flame failure, and selection of either 4 or 10 second timed trial for pilot flame ignition. Plug-in prepurge timer (ordered separately) allow selection of 10, 30 or 60 second timing. Electrical rating: 120v AC (+10%, -15%)

R7795A - Provides ignition cutoff and intermittent pilot. Ultra- violet flame detection; use with C7027A, C7035 “Minipeeper” ultraviolet flame sensor. R7795B - Provides ignition cutoff and intermittent pilot. Rectify- ing flame detection; use with flame rod, rectifying photocells or C7012A, -C “Purple Peeper” ultraviolet flame sensors.

CAT. NO. MFG. NO. 1C612 1C613 1C616 1C617 1C618

R7795A1001 R7795B1009 ST795A1023 ST795A1031 ST795A1049

FLAME DETECTOR TYPE Ultraviolet

Rectification

10 sec Plug-in Prepurge Timer 30 sec. Plug-in Prepurge Timer 60 sec. Plug-in Prepurge Timer

EACH

$2,143.82 $2,143.82 $187.50 $187.50 $187.50

Visit us at www.remichel.com 759

CONTROLS