MARS Motor Protector solve the problem of finding suitable replacements for motor overloads protectors. These overloads will replace most standard overloads on 1/20th thru 1/2 HP at 115V and 1/12th thru 1 HP at 230V. Used in refrigeration, room air condi- tioners, refrigerators, freezers and motors. Each overload has 6” leads and two wire nuts for simple installation.
Intended for use as a starting assist for PSC air conditioning com- pressors. This kit utilizes a positive temperature coefficient solid state material which when wired in parallel with the run capacitor of a PSC motor, provides additional starting torque. PTC device re- quires a 3 minute cool-down period before recycling and therefore cannot be used on a system wired for capacitor off-cycle crankcase heat.
Note: The guide is for “Quick Selection” only. Refer to manufacturers’ cross reference by part number for exact replacements.
110/115V
QUICK GUIDE HORSEPOWER
1/20 1/12 1/8 1/6 1/5 1/4 1/3 1/2
With OEM approval for permanent installation. Approved by Ducane, Goodman and York to re- place original equipment manufacturers start kits.
208/240V 1/12 1/8 1/6 1/5 1/4 1/3 1/2 1
For single phase 208v to 265v A/C, refrigeration and heat pump compressors. Kickstart® hard start devices utilize a start capaci- tor/potential relay combination to allow air conditioning and heat pump compressors to start with maximum efficiency thus reach- ing normal rated speed at up to 10 times faster than compressors without hard start device installed.
CAT. NO. MFG. NO. USE WITH: EACH 8G8911 8G8912
TO-5 KS1
1 to 3 HP 3.5 to 5 HP
$90.44 $81.94
HEAT PUMP DEFROST TIMER
Electro-mechanical defrost timer for time initiated/ time or temperature terminated applications. Provides 10 minute defrost periods at 45 or 90 minute select- able intervals; 2-SPST switches, 240v AC operation. Exact replacement for General Electric and Paragon controls used as original equipment on Carrier, Bryant and Trane heat pumps.