This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
GENERAL GUIDE FOR CUTTING SPEEDS AND FEEDS FOR DRILLS
The following information is a general guide. Specific jobs may need to be modified because of varying job conditions, such as coolant, equipment and job requirements.
GUIDE FOR DRILL FEEDS Drill feeds are governed by the size of the drill and also the material to be drilled.
The lower feeds should be used when drilling relatively hard materials such as alloy steels. The higher feeds should be used when drilling relatively soft materials such as aluminum and brass.
These feeds are based on the peripheral speed of a drill.