This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
The 649 Spindle Square offers accuracy, convenience and significant time saving with the common shop task of tramming the head of a vertical milling machine. This must be done regularly to ensure squarness and perpendicularity between the spindle and work surface.
The spindle square is easier to use and more precise than the traditional method of tramming with a dial test indicator.
USING THE SPINDLE SQUARE
After setting the spindle square indicators to "0" on a surface plate, place the Spindle Square into the collet of the milling machine and bring the head down to the table until both indicator needles have rotated approximately one full rotation.
The needles do not need to point in the same direction. Identical numerical readings, not the needle positions, indicate squareness.
To tram the milling machine, adjust the machine per normal procedures until both indicators read the same numerical value. After setting the X-axis, repeat the same procedure with the Y-axis.
649 Spindle Square Range .250" .125"
2.5mm
Graduation .001"
.0005" 0.01mm
Dial Reading 0-50-0 0-25-0 0-50-0
Cat. No. 649-1 649-5
649-1M EDP
52080 52081 52082
FEATURES AND SPECIFICATIONS
• Fully assembled with two AGD Group 2 dial indicators
• Patented design
• Solid steel body construction with durable black oxide finish
• Ground gaging surface • Approximately 4lbs with custom case • 3/8" inch shank diameter • 4" (100mm) between contact points • Approximately
6-3/4" (172mm) wide and 5"
(140mm) from the top of shank to the end of the contact points
649-1
Check out our website for interactive features at starrett.com