This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
This protractor can be used with the 47 Universal Bevel by setting it against the revolving stud, which quickly and economically converts it into a Bevel Protractor. Protractor has double graduations from 0-180º in opposite directions.
Steel Protractor Range Cat. No. EDP 0-180º 193 50696
193
47 UNIVERSAL BEVEL 6"/150MM
This improved Universal Bevel has both offset and straight slots in the blade, in combination with straight slots in the stock that allow for a wide variety of adjustment and angle settings that are impossible to obtain with many ordinary bevels.
Length of the blade is 6" (150mm), and the stock, 3-1/2" (90mm). The stock lies flat on the work or paper since the head of the clamping bolt is recessed. This tool can be set to duplicate an angle from a master, or it may be easily converted into a Bevel Protractor by using this tool with the 193 Protractor.
Universal Bevel Blade Length Cat. No. EDP 6"
47 50266 47
SPECIAL DIAL PROTRACTOR HEADS
We make dial protractor heads for special applications that permit rapid angular measurements over a 90º range, in increments of 5 minutes.
These special tools are similar to AGD Group-2 Dial Indicators. They have a rear-mounted rotary input shaft attached to a movable arm that measures the angle in relation to a fixed arm.
They are available with continuous or balanced dials and with clockwise or counterclockwise reading.
(See our Special Gage section for more information.)