This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
268 V-BLOCKS AND CLAMP 1-1/8"/28MM CAPACITY • Cast iron construction • 1-1/2" (38mm) square and 2" (50mm) long
• Clamp is ribbed for extra strength and will hold work up to 1-1/8" (28mm) in diameter
268 V-Blocks and Clamp Capacity
Inch mm 1-1/8 28
Description 2 V-Blocks (One Pair)
Complete Set with 2 V-Blocks (One Pair) and Clamp Clamp Only
271 V-BLOCKS AND CLAMP 1-1/4"/32MM CAPACITY • Case hardened steel for wear resistance • For use singly or in pairs
• Includes a steel rod that passes through each block, firmly held by friction positioning to keep blocks in alignment
• Two grooves on each side of the blocks will hold the clamp for small or large work
• Steel forged clamp holds work up to 1-1/4" (32mm) in diameter
271 V-Blocks and Clamp Capacity
Inch mm 1-1/4 32
Description 2 V-Blocks (One Pair)
Complete Set with 2 V-Blocks (One Pair) and Clamp Clamp Only
Cat. No. EDP 271A 271C 271B
278 V-BLOCKS AND CLAMPS 1"/25MM CAPACITY • Precision ground to extreme accuracy • Vees are central, parallel, and square with the ends and sides • Hardened and ground steel construction • Numbered in series so the vees in each set are always in alignment
• 1/4-20 tapped hole through the sides for attachment to an angle iron that can then be attached to a lathe faceplate or held by a magnetic chuck
• Each block is 1-1/4" (32mm) square and 1-5/8" (40mm) long
278 V-Blocks and Clamps Capacity
Inch mm 1
25 Description
Complete Set with 2 V-Blocks (One Pair) and 2 Clamps
Clamp Only PRECISION V-BLOCKS AND CLAMPS
Starrett V-Blocks come in a variety of styles to suit the numerous requirements of machinists. They are for general shop use and layout work, as well as for holding stock in place during light-duty milling, drilling, and grinding operations. All clamp screws have a hole to help secure the workpiece.