This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
With direct reading capability to .0001" or 0.002mm, these gages provide a rapid means for calibrating both AGD and dial test indicators for linearity and repeatability through ranges up to 1" or 25mm. This tester design is unlike others because it can be swung to any position between vertical and horizontal by loosening a large hand knob which fastens the gage assembly to the base.
In addition, the micrometer head can be turned on its axis and its scale positioned to suit the operator's convenience by loosening a single set screw. Tensioned locking screws prevent tipping of both the gage assembly and the indicator holding clamp during set-up and adjustment.
The micrometer head is our 469 super-precision head with reverse reading capability. When testing a 2600 or 2700 Electronic Indicator, a .000050" graduated head is advisable, available on special order.
An indicator mounting attachment holds dovetail mount indicators, AGD indicators with 3/8" (9.5mm) stems and indicators with a holder that has a 3/16" (4.7mm) shank. Unit also has a fine adjustment to zero the indicator.
716 Indicator Tester (0-1" Range)
Micrometer Head Graduation*
.0001" Description
716M Indicator Tester (0-25mm Range) 0.002mm
Indicator mounting attachment only *Available on special order with resolution to .000050" or 0.001mm. Cat. No. EDP
Tester with carbide faced spindle, indicator mounting and offset attachment 716X 67228
Tester with carbide faced spindle, indicator mounting and offset attachment 716MX 67229
Accessory for 716, 716M Indicator Testers Description
Cat. No. EDP PT26009 65102
716MX
Dial test indicator held in place by an offset attachment
Checking AGD dial indicator
Check out our website for interactive features at starrett.com