This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
True squares are designed for fast, precision indexing with angle gage blocks.
All faces of Webber True Squares are at precisely 90º to adjacent sides, with perfect optical flatness and parallelism to permit use with autocollimators.
Applications for fast precision indexing and setting of angular grinding fixtures are almost unlimited. For example: the work and the true square are mounted together on a revolving fixture. A notch is ground by two successive cuts, one at 90º with the true square, and the other at 2º with the addition of two angle blocks (+3º and –1º) mounted on square. An indicator reading is taken before each grind. This process is then repeated by turning the True Square to successive zero readings.
True Squares are designed for use as an accessory to our angle gage blocks to easily make angles greater than 45° and through 180°.
Webber True Squares also permit a fast, easy check of indexing tables. The gaging faces are at precise 90° angles with optical flatness and finishes that permit the use of autocollimators.
The catalog numbers and specifications of our True Squares have been changed in response to updated requirements concerning the application of the uncertainty of measurement.
True Square Specifications Cat. No. Grade
Material
Tolerances: Deviation From Nominal
Flatness of Gaging Surfaces Flatness & Parallelism of Sides
Squareness of Sides to Gaging Surfaces Area of Gaging Surfaces†
Surface Finish (Gage Surfaces Only)
TS 21.R
Reference croblox®
±1.0 second 6µin. (0.15µm)
8µin. (0.20µm) 6 seconds
1" x 2" (25 x 50mm) 0.4µin. AA (0.01µm AA)
Estimated Uncertainty of Measurement (K=2) 0.6 seconds
TS 21.C
Calibration Steel
±2.0 second 8µin. (0.20µm)
8µin. (0.20µm) 8 seconds
1" x 2" (25 x 50mm) 0.6µin. AA (.015µm AA) 1.0 seconds
TS 44.W Working Steel
±5.0 second
14µin. (0.35µm)* 16µin. (0.40µm)* 12 seconds
5/8" x 4" (16 x 100mm) 1.0µin. AA (.025µm AA) 3.5 seconds
Flatness tolerances exclude 1.5mm from the edges on all angle blocks except where marked with *. Then, 3mm from the edge is excluded. † Dimension of gaging surfaces in millimeters is approximate.
TS 66.W Working Steel
±5.0 second
14µin. (0.35µm)* 16µin. 0.40µm)* 12 seconds
5/8" x 6" (16 x 150mm) 1.0µin. AA (.025µm AA) 4.0 seconds
Check out our website for interactive features at starrett.com