This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
These indicating gages are ideal for obtaining fast, comparative I.D. measurements, especially in hard-to-reach locations. The user depresses the button on the indicator housing and releases, allowing the arms to make contact with the work.
• Makes convenient, accurate I.D. measurements
• Spring loaded design provides constant pressure and positive contact for reliable measurements
• Can be set with a micrometer or ring gage • 3-1/4" arm length for ample reach • Rotatable bezel for zero setting and bezel lock • Jewel bearings • .040" (1.016mm) dia. carbide ball measuring contacts
1019 and 1019M Internal Dial Caliper Gages Range
Description
.400-1.4" .001" with Revolution Counter 10-35mm 0.025mm with Revolution Counter
These gages are used between two walls to check parallelism and also to take comparative measurements of internal diameters. There are ten rods and one extension furnished. The rods are marked to designate the approximate overall length of the gage. All measuring contacts are rounded. Tool can be set with a micrometer.
The indicator bezel is rotated to adjust the dial in relation to the hand and has a non-breakable crystal. The movement of the dial indicator is approximately 5/32" (4mm). Rods of different lengths can also be furnished on request.
697 and 697M Inside Dial Gages Range
2-3/8–18" .001"
Graduation Dial Reading One Revolution Cat. No. EDP 0-20-0