This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
Individually designed and built for each application, these gages have a low-friction ball bushing direct- transfer mechanism and will repeat within one graduation.
It is made of aluminum for light weight and to preserve the proper "feel". Gage contacts and rest feet are carbide for long wear.
The steel tube master has carbide rests and pads for accuracy and wear control.
Shown here is an angled outside diameter gage in position on the setting master to set the indicator to zero.
This specific gage was designed to measure the diameter on conical parts.
INSIDE DIAMETER GAGE Inside diameter gage,
Angled outside Diameter Gage with Setting Master
moderately deep reach.
Design permits inside measuring, while clearing hub obstructions. (Conventional straight bar would be used otherwise).