This content requires Adobe Flash Player version
or later.
Either you do not have Adobe Flash Player installed,
or your version is too old,
or there is a problem with your Flash installation and we were unable to detect it.
These parallel clamps are designed for maximum strength and rigidity. They are extremely useful for holding work together in tapping and drilling and on various machine setups. The ends of the jaws are rounded to permit clamping under shoulders or in recesses.
A retaining ring holds the loose jaw in alignment when the clamp is being opened or closed. The clamps are made of steel, nicely finished and hardened.
580 PRECISION ANGLE PLATE
These angle plates are invaluable for accurate work in toolroom and small production applications when flatness, squareness and parallelism is important.
• Hardened and tempered steel • Precision ground,
square and parallel
• Convenient step for smaller work 3/4" (19mm) down from the top and a 1/4" (6.35mm) seat
• 10 holes tapped with a 1/4- 20 thread for fastening to fixtures and clamping work to the angle plate
161 Toolmakers' Parallel Clamps Capacity
Inch mm Inch 3/4" 19mm 21/32" 1-1/4" 32mm 13/16" 1-3/4" 44mm 1"
54 HOLD-DOWNS • Improved design firmly holds work flat on a machine bed or in a vise