8B-116 Air Bag System:
6) Disconnect side-sensor connector sliding connector
outer (1) as shown.
1
1
1
1
I4RS0A820106-
4) Connect negative cable at battery.
I4RS0A820109-
5) Enable air bag system. Refer to “Enabling Air Bag
Installation
System: ”.
CAUTION:
Side-Sensor Inspection
S4RS0A8206024
Proper operation of side-sensor requires
WARNING:
sensor be rigidly attached to specified
position.
During service procedures, be very careful
when handling a sensor.
1) Check that none of following faulty conditions exists. • Never strike or jar a sensor.
• Bend, deformity or rust of under body. • A sensor and mounting bracket bolts must
• Foreign matter on mating surface of sensor.
be carefully torqued to assure proper
2) Install side-sensor (1) on under body (2) and tighten
operation. Under loose connection, it
side-sensor bolt (3) to specified torque.
could cause improper operation of the air
bag system.
Tightening torque
Side-sensor bolt (a): 9 N·m (0.9 kg-m, 6.5 lb-ft)
CAUTION:
• Never disassemble side-sensor.
• Sensor should be replaced when it was
dropped from a height of 90 cm (3 ft) or
more.