Air Bag System: 8B-71
NOTE:
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components and ensure all components are properly mounted.
• Clear DTCs referring to “DTC Clearance: ”, if any.
• Repeat “Air Bag Diagnostic System Check: ” to confirm that the trouble has been corrected.
DTC B1061 / B1065: Driver / Passenger Side-Air Bag Initiator Circuit Resistance High
S4RS0A8204072
Wiring Diagram
5 “L29”
“L25”
“L04”
4
1
GRN RED DS+
L29-11
WHT/RED
2
L29-26 IG
“G32” DS- L29-10
WHT/GRN
6
3
BLK
Y/BLU
L29-27 E1
PS+ L29-12
GR
[A]
8
7
“L29”
PS- L29-13
LT GRN/RED
“L30”
I4RS0A820031-
[A]: Shorting bar 3. “A/BAG” fuse 6. Driver side-air bag (inflator) module
1. From main fuse 4. Junction block assembly 7. Passenger side-air bag (inflator) module
2. Ignition switch 5. SDM 8. Ground for air bag system
CAUTION:
• Be sure to perform “Air Bag Diagnostic System Check: ” before starting diagnosis according to
flow.
• When measurement of resistance or voltage is required in this flow, use a tester along with a correct
terminal adapter from special tool (Connector test adapter kit).
• When a check for proper connection is required, refer to “Inspection of Intermittent and Poor
Connections: ”.
• If there is open circuit in the air bag wire harness, connector or terminal is found damaged, replace
the wire harness, connector and terminal as an assembly.