8B-112 Air Bag System:
Installation Side-Air Bag (Inflator) Inspection
1) Confirm sleeve (1) is surely installed in side-air bag
S4RS0A8206022
WARNING:
(inflator) module.
2) Tighten sleeve lock nut (2) to specified torque. • Never attempt to disassemble or repair the
side-air bag (inflator) module. If any
Tightening torque
abnormality is found, be sure to replace it
Sleeve lock nut (a): 2.5 N·m (0.25 kg-m, 2.0 lb-ft)
with new one as an assembly.
3) Install new clip to seat back.
• Be sure to read “Precautions on Service
and Diagnosis of Air Bag System: ” before
2, (a)
1
starting to work and observe every
precaution during work. Neglecting them
may result in personal injury or
undeployment of the air bag when
necessary.
I4RS0A820073-
4) Connect side-air bag (inflator) module connector (1)
securely as shown in figure.
a) Connect connector.
b) Lock connector with lock button (2).
I4RS0A820075-
CAUTION:
If air bag (inflator) module was dropped from
a height of 90 cm (3 ft) or more, it should be
2
b)
replaced.