Power Assisted Steering System: 6C-6
DTC Check DTC Clearance
S4RS0A6304008 S4RS0A6304009
1) Turn ignition switch to OFF position. 1) Turn ignition switch to OFF position.
2) Connect SUZUKI scan tool to data link connector 2) Connect SUZUKI scan tool to data link connector
(DLC) (1) located on underside of instrument panel (DLC) (1) located on underside of instrument panel
at driver’s seat side. at driver’s seat side.
Special tool Special tool
(A): SUZUKI scan tool (A): SUZUKI scan tool
(A) (A)
1 1
I4RS0A630005- I4RS0A630005-
3) Turn ignition switch to ON position. 3) Turn ignition switch to ON position.
4) Read DTC according to the instructions displayed on 4) Erase DTC according to the instructions displayed
SUZUKI scan tool. For further details, refer to on SUZUKI scan tool. For further details, refer to
operator’s manual for SUZUKI scan tool. operator’s manual for SUZUKI scan tool.
NOTE:
5) After completing the clearance, turn ignition switch to
OFF position and disconnect SUZUKI scan tool from
If communication between SUZUKI scan tool
DLC.
and the vehicle can not be established,
perform “Serial Data Link Circuit Check: ”.
5) After completing the check, turn ignition switch to
OFF position and disconnect SUZUKI scan tool from
DLC.
DTC Table
S4RS0A6304010
CAUTION:
Be sure to perform the “EPS System Check: ” before starting troubleshooting corresponding to each
DTC.