Air Bag System: 8B-45
DTC B1041: Passenger Air Bag Initiator Circuit Resistance High
S4RS0A8204012
Wiring Diagram
5
“L29”
“L04”
“L32” “G04”
“G10”
1
GRN
4
RED
2
L29-26 IG
“G32”
P+ L29-4
YEL/RED YEL/RED
3
BLK
P- L29-5
YEL/GRN YEL/GRN
6
L29-27 E1
[A]
7
“L29”
I4RS0A820020-
[A]: Shorting bar 3. “A/BAG” fuse 6. Passenger air bag (inflator) module
1. From main fuse 4. Junction block assembly 7. Ground for air bag system
2. Ignition switch 5. SDM
CAUTION:
• Be sure to perform “Air Bag Diagnostic System Check: ” before starting diagnosis according to
flow.
• When measurement of resistance or voltage is required in this flow, use a tester along with a correct
terminal adaptor from special tool (Connector test adapter kit).
• When a check for proper connection is required, refer to “Inspection of Intermittent and Poor
Connections: ”.
• If there is open circuit in the air bag wire harness, connector or terminal is found damaged, replace
the wire harness, connector and terminal as an assembly.