Steering Wheel and Column: 6B-4
1 1
2 2
I4RS0A620008- I4RS0A620011-
5) Remove contact coil cable assembly (1) from 4) Install steering wheel to steering column. Refer to
steering column. “Steering Wheel Removal and Installation: ”.
5) Connect battery negative (–) cable.
6) Enable air bag system referring to “Enabling Air Bag
System: in Section 8B”.
Centering Contact Coil Cable Assembly
S4RS0A6206003
1) Check that vehicle’s wheels (front tires) are set at
straight-ahead position.
2) Check that ignition switch is at LOCK position.
1
3) Turn contact coil counterclockwise slowly with a light
I4RS0A620009-
force till contact coil will not turn any further.
Installation
NOTE:
1) Check to make sure that vehicle’s front tires are set
Contact coil can turn about 5 turns at the
at straight-ahead position and then ignition switch is
maximum, that is, if it is at the center
at LOCK position.
position, can turn about two and a half turns
both clockwise and counterclockwise.
2) Install contact coil cable assembly (1) to steering
column securely.
NOTE:
New contact coil cable assembly is supplied
with contact coil set and held at its center
position with a lock pin (1). Remove this lock
pin after installing contact coil cable
assembly to steering column.