Air Bag System: 8B-15
Step Action Yes No
6 1) Disconnect combination meter connector “G28” referring Substitute a known- “BLU/ORN” wire
to “Combination Meter Removal and Installation: in good SDM and recheck. (between combination
Section 9C”. If “AIR BAG” warning meter and SDM
2) Check proper connection to combination meter at “BLU/
lamp remain lighting, connector) open or
ORN” terminal for “AIR BAG” warning lamp and to SDM
replace combination short to ground.
at terminal “L29-1”.
meter.
3) If OK, then check resistance between “BLU/ORN” wire
terminal of combination meter connector “G28” and
“L29-1” terminal of SDM connector.
Special tool
(A): 09932-76010
"L29-1"
(A)
"G28-12"
I4RS0A820101-
Is resistance 1 Ω or less?
NOTE:
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components and ensure all components are properly mounted.
• Repeat “Air Bag Diagnostic System Check: ” to confirm that the trouble has been corrected.