8B-34 Air Bag System:
Step Action Yes No
4 1) With ignition switch OFF, disconnect special tools (B) Turn ignition switch Turn ignition switch
and (C) from “G26” connector and reconnect contact coil OFF. Replace contact OFF. Replace driver air
connector located under of the steering column. coil assembly referring bag (inflator) module
2) Remove driver air bag (inflator) module from steering
to “Contact Coil Cable referring to “Driver Air
column referring to “Driver Air Bag (Inflator) Module
Assembly Removal and Bag (Inflator) Module
Removal and Installation: ”.
Installation: in Section Removal and
3) Check proper connection to driver air bag (inflator)
6B”. Installation: ”.
module connector.
4) If OK, then connect special tools (A), (B) and (E) to
driver air bag (inflator) module connector.
Special tool
(A): 09932-76010
(B): 09932-75010
(C): 09932–78340
(E): 09932-78310
(A)
(E)
(B)
STEERING WHEEL
I4RS0A820017-
5) Check SDM DTC.
With ignition switch ON, is DTC B1032 indicated?
NOTE:
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components and ensure all components are properly mounted.
• Clear DTCs referring to “DTC Clearance: ”, if any.
• Repeat “Air Bag Diagnostic System Check: ” to confirm that the trouble has been corrected.