Air Bag System: 8B-29
Step Action Yes No
4 1) With ignition switch OFF, disconnect special tools (B) Turn ignition switch Turn ignition switch
and (C) from “G26” connector and then reconnect OFF. Replace contact OFF. Replace driver air
contact coil connector located under of the steering coil assembly referring bag (inflator) module
column. to “Contact Coil Cable referring to “Driver Air
2) Remove driver air bag (inflator) module from steering
Assembly Removal and Bag (Inflator) Module
wheel referring to “Driver Air Bag (Inflator) Module
Installation: in Section Removal and
Removal and Installation: ”.
6B”. Installation: ”.
3) Check proper connection to driver air bag (inflator)
module connector.
4) If OK, then connect special tools (A), (B) and (E) to
driver air bag (inflator) module connector.
Special tool
(A): 09932-76010
(B): 09932-75010
(C): 09932–78340
(E): 09932-78310
(A)
(E)
(B)
STEERING WHEEL
I4RS0A820017-
5) Check SDM DTC.
With ignition switch ON, is DTC B1031 indicated?
NOTE:
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components and ensure all components are properly mounted.
• Clear DTCs referring to “DTC Clearance: ”, if any.
• Repeat “Air Bag Diagnostic System Check: ” to confirm that the trouble has been corrected.