Air Bag System: 8B-69
NOTE:
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components and ensure all components are properly mounted.
• Clear DTCs referring to “DTC Clearance: ”, if any.
• Repeat “Air Bag Diagnostic System Check: ” to confirm that the trouble has been corrected.
DTC B1054 / B1058: Driver / Passenger Pretensioner Initiator Circuit Short to Power Circuit
S4RS0A8204027
Wiring Diagram
5 “L29”
“L10”
“L04”
PNK
1
GRN
4
RED DP+ L29-7
2
L29-26 IG
“G32” DP- L29-6
WHT
6
3
BLK
L29-27 E1
PP+ L29-8
BRN
[A]
8
“L29”
PP- L29-9
LT GRN
7
“L36”
I4RS0A820026-
[A]: Shorting bar 3. “A/BAG” fuse 6. Driver seat belt pretensioner
1. From main fuse 4. Junction block assembly 7. Passenger seat belt pretensioner
2. Ignition switch 5. SDM 8. Ground for air bag system
CAUTION:
• Be sure to perform “Air Bag Diagnostic System Check: ” before starting diagnosis according to
flow.
• When measurement of resistance or voltage is required in this flow, use a tester along with a correct
terminal adapter from special tool (Connector test adapter kit).
• When a check for proper connection is required, refer to “Inspection of Intermittent and Poor
Connections: ”.
• If there is open circuit in the air bag wire harness, connector or terminal is found damaged, replace
the wire harness, connector and terminal as an assembly.