8B-78 Air Bag System:
Step Action Yes No
3 1) With ignition switch OFF, disconnect special tools (B) DTC B1062: Repair Replace side-air bag
and (C) then reconnect connector “L25” or “L30”. short from “WHT/RED” (inflator) module
2) Disconnect side-air bag (inflator) module connector (1)
wire circuit to “WHT/ referring to “Side-Air
from side-air bag (inflator) module.
GRN” wire circuit in seat Bag (Inflator) Module
3) Check proper connection to side-air bag (inflator)
harness or from “WHT/ Removal and
module at terminal in connector.
RED” or “WHT/GRN” Installation: ”.
wire circuit to other wire
4) If OK, then connect special tools (A), (B) and (C) to side-
circuit.
air bag (inflator) connector.
DTC B1066: Repair
Special tool
short from “GRY/BLU”
(A): 09932–76010
wire circuit to “LT GRN/
(B): 09932–75010
RED” wire circuit in seat
(C): 09932–78310
harness or from “GRY/
BLU” or “LT GRN/RED”
wire circuit to other wire
1
circuit.
(A)
(C)
(B)
STEERING WHEEL
“L25”, “L30”
I4RS0A820034-
5) Check SDM DTC.
With ignition switch ON, is DTC B1062 or B1066 still
indicated?
NOTE:
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components, ensure all components are properly mounted.
• Clear DTCs referring to “DTC Clearance: ”, if any.
• Repeat “Air Bag Diagnostic System Check: ” to confirm that the trouble has been corrected.