8B-60 Air Bag System:
Step Action Yes No
3 1) With ignition switch OFF, disconnect special tools (B) Substitute a known- “YEL/RED” or “YEL/
and (C) from “L32” connector and SDM connector “L29” good SDM and recheck. GRN” circuit shorted to
from SDM respectively. power supply circuit in
2) Release shorting bar in SDM connector inserting release
floor harness.
tool (1) included in special tool (A).
3) Measure voltage from “L29-4” terminal to body ground
and from “L29-5” terminal to body ground.
Special tool
(A): 09932-76010
(B): 09932-75010
(C): 09932–77320
"L29-4" "L29-5"
(A)
"L32"
(C)
DRIVER
PASSENGER
(B)
BASE OF COLUMN
I4RS0A820025-
With ignition switch ON, is voltage 1 V or less?
NOTE:
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components and ensure all components are properly mounted.
• Clear DTCs referring to “DTC Clearance: ”, if any.
• Repeat “Air Bag Diagnostic System Check: ” to confirm that the trouble has been corrected.