Air Bag System: 8B-95
Step Action Yes No
2 1) With ignition switch OFF, disconnect SDM connector Substitute a known- DTC B1361: Repair
“L29”. good SDM and recheck. high resistance or open
2) Check proper connection to SDM at terminals “L29-18”
in “RED/BLU” or “YEL/
and “L29-19” or “L29-20” and “L29-21”.
BLK” wire circuit.
3) If OK, release shorting bar in SDM connector inserting
DTC B1365: Repair
release tool (1) included in special tool (A).
high resistance or open
4) Measure resistance between “L29-18” and “L29-19”
in “BLU/RED” or “BLU/
terminals (for DTC B1361) or “L29-20” and “L29-21”
YEL” wire circuit.
terminals (for DTC B1365) with connected special tools
(A), (B) and (C).
Special tool
(A): 09932–76010
(B): 09932–75010
(C): 09932–78310
"L29-18""L29-19""L29-20""L29-21"
(A)
"L17", "L41"
(A)
(C)
(B)
STEERING WHEEL
I4RS0A820097-
Is resistance 2.82 Ω or less?
NOTE:
Upon completion of inspection and repair work, perform the following items.
• Reconnect all air bag system components, ensure all components are properly mounted.
• Clear DTCs referring to “DTC Clearance: ”, if any.
• Repeat “Air Bag Diagnostic System Check: ” to confirm that the trouble has been corrected.