8B-114 Air Bag System:
CAUTION:
If air bag (inflator) module was dropped from
a height of 90 cm (3 ft) or more, it should be
replaced.
Check air bag (inflator) module appearance visually for
the following symptoms and if any one of them is found,
2
b) replace with a new one.
• Air bag has deployed.
• Inflator case being damaged or having been exposed
a)
1
to strong impact (dropped).
I4RS0A820055-
4) Install head lining referring to “Head Lining Removal
Forward-Sensor Removal and Installation
and Installation: in Section 9H”. S4RS0A8206009
5) Enable air bag system. Refer to “Enabling Air Bag
WARNING:
System: ”.
During service procedures, be very careful
when handling a sensor.
Side Curtain-Air Bag (Inflator) Module
• Never strike or jar a sensor.
Inspection
• A sensor and mounting bracket bolts must
S4RS0A8206026
be carefully torqued to assure proper
WARNING:
operation. Under loose connection, it
could cause improper operation of the air
• Never measure resistance of side curtain-
bag system.
air bag (inflator) module or disassemble it.
Otherwise personal injury may result.
Removal
• Never attempt to disassemble or repair the
1) Disconnect negative cable at battery.
side curtain-air bag (inflator) module. If any
abnormality is found, be sure to replace it
2) Disable air bag system referring to “Disabling Air
with new one as an assembly.
Bag System: ”.
• Be sure to read “Precautions on Service
3) Disconnect forward-sensor connector sliding
and Diagnosis of Air Bag System: ”,
connector outer (2) as shown.
“Precautions on Handling and Storage of
Air Bag System Components: ” and
1
“Precautions on Disposal of Air Bag and
Seat Belt Pretensioner: ” before starting to
work and observe every precaution during
work. Neglecting them may result in
personal injury or undeployment of the air
bag when necessary.