HOSSFELD UNIVERSAL
®
Model No. 2 Bender ANGLE IRON
Angle Iron – ASTM A36 Hot Rolled Mild Steel (HRMS)
Inside Radius (IR) – Radius bends in Angle Iron “Heel-Out” are measured from the center
of the bend to the inside edge of the heel.
Stock Capacity
Angle Iron ........ 1/8" x 1/2" x 1/2" through 3/16" x 1-1/2" x 1-1/2"
20B10 Feed-Along Angle Iron Dies –
“Heel-Out”
Bend Angle Iron “Heel Out” from 10" to 20" Radius
Tooling consists of a Master Back Block/Draw Block Set for
ALL radius sizes and a 20B10 Form Die for the desired radius.
Form Dies have dual working faces for bending two different radii.
20B10 Feed-Along Form Dies
PART NO. IR
43400 10" / 12"
43404 18" / 20"
Block Set
20B10 Form Die with 42990 Back Block/Draw Block Set bending Angle Iron
PART NO. DESCRIPTION
with the “Heel Out”
42990 Back Block/Draw Block Set for ALL radii
BACK BLOCK
DRAW BLOCK
20B10 FORM DIE
Radius bend in Angle Iron: HOSSFELD UNIVERSAL
®
parts and dies are
“Heel-Out” (shown on left) and “Heel-In” (shown on right)
designed to be used with HOSSFELD UNIVERSAL
®
Benders. Use of other benders with HOSSFELD
UNIVERSAL
®
parts and dies may cause inferior performance
or lead to breakage of such parts or dies.
42
www.hossfeldbender.com
Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43  |  Page 44  |  Page 45  |  Page 46  |  Page 47  |  Page 48