HOSSFELD UNIVERSAL
®
Model No. 2 Bender ANGLE IRON
Angle Iron – ASTM A36 Hot Rolled Mild Steel (HRMS)
Vertical Leg Inside Radius (IR) – Radius bends in Angle Iron are measured from the center
of the bend to the inside edge of the vertical leg.
Stock Capacity
Angle Iron .............. 1/8" x 3/4" x 3/4" through 1/8" x 1-1/4" x 1-1/4"
102B 180° “One Pull” Angle Iron Die
Sets – “Leg-In”
Bend Small Radii Up to 180° With Just “One Pull”
Form short-radius 180° bends in Angle Iron with “One Pull” and without
wrinkling. Special Cam-type Form Die and “Hold-Down Arms” lock the
stock in place to prevent torquing or twisting.
PART NO. IR
102B Form Die with attached Hold-Down Arms bending wide U-bend in Angle Iron,
“Leg-In”, to a 2-3/4" radius
37415 2-3/4"
37465 3"
37520 3-3/8"
102B
Stock Maximum Capacity
Angle Iron ................................. 5/16" x 2-1/2" x 2-1/2"
35B “Notched” Angle Iron Die
Notch Your Angle Iron; Then Bend It Closed
To Form Sharp Corners
Form sharp bends in Angle Iron, “Leg-In” after the point of the bend
has been notched. Also forms sharp “V” bends in Flat Stock.
PART NO. DESCRIPTION
20872 35B Notched Angle Iron Die
35B Notched Angle Die bending notched Angle Iron, “Leg-in”
“Notched” Angle Iron 35B
40
www.hossfeldbender.com
Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43  |  Page 44  |  Page 45  |  Page 46  |  Page 47  |  Page 48