This page contains a Flash digital edition of a book.
research  review Tiny cylinder-shaped lasers show


promise for PICs Microlasers deliver continuous-wave single-mode-operation at room temperature


CHINESE researchers have connected InAlGaAs/InP cylinder microlasers with a


radius of 15 µm using two 2 µm wide output waveguides fabricated by a novel planar technology process. Continuous- wave (CW) electrically injected single- mode-operation is realised at room temperature with side-mode suppression of 32 dB.


Electrically injected directional emission microlasers are potential light sources for photonic integrated circuits. Circular microlasers are most commonly used as whispering-gallery mode (WGM) microlasers. However, the total internal reflection of WGM in circular resonators limits the directional emission from the microlasers. Directional emission circular microlasers have previously been investigated by evanescent-wave coupling or directly connecting with an output waveguide.


Optical memory has also been achieved using InP-based microdisk lasers vertically integrated with a silicon-on-insulator (SOI) waveguide, where two sides of the SOI waveguide work as input and output ports. More recently, researchers fabricated a two-port InGaAsP/InP square resonator microlaser; this emitted light from one cleaved port, and a circular microresonator was predicted to realise multiple-port directional emission based on the coupled modes.


Now scientists based at the Chinese


Academy of Sciences in Beijing are reporting the fabrication of AlGaInAs/InP


cylinder microlasers with radius of 15 µm connected with two 2-µm-wide output waveguides. The microlasers have


achieved continuous-wave (CW) electrically injecting single-mode-operation at room temperature.


A common edge-emitting AlGaInAs/InP laser wafer, which consists of six compressively strained quantum wells sandwiched between 100 nm AlGaInAs cladding layers, is used to fabricate the cylinder microlasers. The thicknesses of the quantum wells and barrier layers are 6 nm and 9 nm, respectively.


The 15-µm-radius AlGaInAs/InP cylinder microlasers with two 2-µm-wide output waveguides are fabricated by firstly,


depositing an 800-nm SiO2 layer using


plasma-enhanced CVD on the laser wafer as a hard mask for dry etching. Then, the circular resonator patterns with the waveguides are transferred onto the SiO2 layer using standard photolithography and inductively coupled-plasma (ICP) etching techniques, and the laser wafer is etched


by about 5.5 µm using ICP technique again with the patterned SiO2


as hard


masks. Ti-Au and Au-Ge-Ni are used as p- contact and n-contact metals, respectively, and the etched sidewalls of the microcylinder are surrounded by insulating SiO2


layer and p-contact metals.


Figure 1 shows the microscope image of a cylinder microlaser, where the waveguides of the port-a and port-b are normal and with a crossing angle of 45 ° to the cleaved facet, respectively, and the lengths


Figure 1.Microscope image of a cylinder microlaser with two output waveguides cleaved for testing


of the waveguides are 25 µm and 38 µm. Output powers coupled into a multimode fiber are measured and plotted as functions of CW injecting current in Figure 2 at room temperature of 20 °C, where the current kinks at 24 mA and 30 mA for port-a and port-b indicate the domination of the stimulated emission in the corresponding waveguide. The extending lines as shown by dashed lines in Figure 2 have the cross points of 14 mA and 16 mA at the current axis for the output power from port-a and port-b, respectively.


42 www.compoundsemiconductor.net August / September 2011


Figure 2.Output power coupled into optical fibre versus the injection current for the cylinder microlaser measured from port-a and port-b


Considering the cross points are corresponding to the threshold current, there are near values of the threshold currents for the two ports. The output power coupled into an optical fiber is 2.0 and 0.67 µW at the injecting current of 50 mA from port-a and port-b, the total internal reflection on the cleaved facet limits the light emission from the port-b. Furthermore, the output power directly measured by butt-coupling a 5 mm- diameter photodetector is larger than


20 µW. So the minor peaks are almost invisible in the laser spectrum of the port-b.


The laser output spectra measured from port-a and port-b are plotted in Figure 3(a) at the injection current of 45 mA. Single mode operation is realised with the lasing wavelength of 1577 nm, and the side mode suppression ratio of 32 dB is obtained from the lasing spectrum of the port-b. The mode wavelength intervals of 7.2~7.6 nm are corresponding to the longitudinal mode intervals of the circular microresonator.


Detailed laser spectra are measured by an optical spectrum analyser with the resolution of 0.067 nm at 25 mA and 25 °C and plotted in the inset of Figure 3(b). The full width at half maximum of 0.087 nm is measured for the resonance peak at 1562.85 nm by fitting a Lorentzian function, and the corresponding mode Q factor of 1.8 x 104


is obtained as the ratio of the peak wavelength to the full width.


Page 1  |  Page 2  |  Page 3  |  Page 4  |  Page 5  |  Page 6  |  Page 7  |  Page 8  |  Page 9  |  Page 10  |  Page 11  |  Page 12  |  Page 13  |  Page 14  |  Page 15  |  Page 16  |  Page 17  |  Page 18  |  Page 19  |  Page 20  |  Page 21  |  Page 22  |  Page 23  |  Page 24  |  Page 25  |  Page 26  |  Page 27  |  Page 28  |  Page 29  |  Page 30  |  Page 31  |  Page 32  |  Page 33  |  Page 34  |  Page 35  |  Page 36  |  Page 37  |  Page 38  |  Page 39  |  Page 40  |  Page 41  |  Page 42  |  Page 43  |  Page 44  |  Page 45  |  Page 46  |  Page 47  |  Page 48  |  Page 49  |  Page 50  |  Page 51  |  Page 52  |  Page 53  |  Page 54  |  Page 55  |  Page 56  |  Page 57  |  Page 58  |  Page 59  |  Page 60  |  Page 61  |  Page 62  |  Page 63  |  Page 64  |  Page 65  |  Page 66  |  Page 67  |  Page 68  |  Page 69  |  Page 70  |  Page 71  |  Page 72  |  Page 73  |  Page 74  |  Page 75  |  Page 76  |  Page 77  |  Page 78  |  Page 79  |  Page 80  |  Page 81  |  Page 82  |  Page 83  |  Page 84  |  Page 85  |  Page 86  |  Page 87  |  Page 88  |  Page 89  |  Page 90  |  Page 91  |  Page 92  |  Page 93  |  Page 94  |  Page 95  |  Page 96  |  Page 97  |  Page 98  |  Page 99  |  Page 100  |  Page 101  |  Page 102  |  Page 103  |  Page 104  |  Page 105  |  Page 106  |  Page 107  |  Page 108  |  Page 109  |  Page 110  |  Page 111  |  Page 112  |  Page 113  |  Page 114  |  Page 115  |  Page 116  |  Page 117  |  Page 118  |  Page 119  |  Page 120  |  Page 121  |  Page 122  |  Page 123  |  Page 124  |  Page 125  |  Page 126  |  Page 127  |  Page 128  |  Page 129  |  Page 130  |  Page 131  |  Page 132  |  Page 133  |  Page 134  |  Page 135  |  Page 136  |  Page 137  |  Page 138  |  Page 139  |  Page 140  |  Page 141  |  Page 142  |  Page 143  |  Page 144  |  Page 145  |  Page 146  |  Page 147  |  Page 148  |  Page 149  |  Page 150  |  Page 151  |  Page 152  |  Page 153  |  Page 154  |  Page 155  |  Page 156  |  Page 157  |  Page 158  |  Page 159  |  Page 160  |  Page 161  |  Page 162  |  Page 163  |  Page 164  |  Page 165  |  Page 166  |  Page 167  |  Page 168  |  Page 169  |  Page 170  |  Page 171  |  Page 172  |  Page 173  |  Page 174  |  Page 175  |  Page 176  |  Page 177  |  Page 178  |  Page 179  |  Page 180